ASP Flying Model Rocket Kit Versi-Loader 2 Payload ASP KVL2-18

ASP Flying Model Rocket Kit Versi-Loader 2 Payload ASP KVL2-18

Versi - Loader kit that has been updated to conform to the latest NAR payload rules. Easy-to-build 18mm engine model. This kit features balsa nose cone and bulkhead, laser-cut balsa fins as well as a complete payload kit. Can be flown either single-stage or two-stage. Although designed primarily as a payload model, the Versi - Loader 2 is also capable of being used as a Parachute or Streamer Duration model in the higher impulse events (B & up) as well as in Altitude events, or even just for fun as a high-flying Sport Model! Includes NAR-Style Payload.

Length(Single-Stage)* 17.75\"(45.1cm)
Length(Two-Stage)* 20.5\"(52.1cm)
Diameter: 0.739\"(1.877cm)
Weight(Single-Stage w/Payload)* 1.75oz(50g)
Weight(Two-Stage w/Payload)* 2oz(56.5g)
Skill Level: 2 Intermediate
Parachute Recovery
Center of Pressure(Single-Stage): 15.3\" from tip of nose cone
Center of Pressure(Two-Stage): 17.3\" from tip of nose cone

* Length and weight may vary depending on how you decide to build the model, see instructions for full details.

Recommended Engines (Single Stage):
A8-3; B6-6; C6-7; C12-8; C18-8; D16-8; D20-8
Recommended Engines (Two Stage):
Booster Stage: A8-0; B6-0; C6-0
Upper Stage: A8-5; B6-6; C6-7

What you\'ll need to build this rocket:

Adhesives – a thin or medium viscosity cyanoacrylate (\"CA\") glue can be used for most steps and is recommended (other adhesives, such as wood glue(Elmer\'s Carpenters Glue, rBond Titebond) or epoxy can be used if you prefer and are familiar with their use, but the use of a CA glue will usually provide the lightest weight model); hobby knife with a sharp #11 blade; pencil; felt tip marker; sandpaper(medium - 220 or 280, fine - 320 or 400, & extra fine - 500 or 600); pencil; Sanding Sealer, Thinner, Small Paint or foam brush(to apply sealer); Spray Paint (such as Rust-Oleum, Krylon, or Testors is recommended. Be sure not to mix different types or brands of paint without testing.) - primer (optional), color(s) as desired (see instructions).
Recommended, but not required: sanding block; extender tip for cyanoacrylate glue; gram scale (see instructions).
Optional (see instructions): accelerator for cyanoacrylate glue; material to fill body tube seams and/or any imperfections in wood parts, such as Elmer’s Carpenters Wood Filler, Interior Spackling Paste, etc.

What else you\'ll need to fly this rocket:

Engines(see list above); Recovery Wadding; Electronic Launch System and Launch Pad; Electronic Altimetersmay be required if flying in competition.

You can read the instructions for this kit byclickinghere.

Made in the USA