ASP Flying Model Rocket Kit Micro Sandia Sandhawk ASP KSAN-MM

ASP Flying Model Rocket Kit Sandia Sandhawk Micro ASP KSAN-MM

The Sandia Sandhawk was developed as an upper stage for sounding rocket systems. The Sandhawk flew three times as a single stage rocket between 1966 and 1974.This Micro kit is designed to use the Quest™ Micro Maxx™ engines and is based on our \"Minimum Diameter\" T-MM body tubes. Includes 3D printed nose cone, Kevlar® shock cord, metallized polyester streamer, water-slide decal and our usual complete instructions. Due to the small parts involved, these kits are not recommended for the first-time modeler. Younger modelers should have the assistance of an adult when trying to construct these small kits.Specifications:
Length: 6.63\"/ 168.3mm
Diameter: 0.282\"/7.16 mm
Approx. Weight: 0.14 oz/4 gm
Skill Level: Intermediate
Scale: 1/41.5 (0.024)
Recovery Device: Streamer
Recommended Engines: Quest™ Micro Maxx™What you\'ll need to build this model:
Adhesives (a quick-curing epoxy glue can be used for most steps and is recommended, cyanoacrylate [“CA”] is recommended for some steps and you may also use throughout if preferred); hobby knife with a sharp #11 blade; straight edge (preferably metal); cellophane (\"Scotch\") tape; double-sided cellophane (\"Scotch\") tape; paint (Spray or bottle paint, such as such as Rust-Oleum, Krylon, or Testors is recommended. Be sure not to mix different types or brands of paint without testing.) - primer (optional), white, fluorescent red, black & clear (optional); sandpaper (medium - 220 or 280, fine - 320 or 400, & [optionally] extra fine - 500 or 600); pencil.
Recommended, but not required: tweezers (or needle nose pliers); sanding block; tack cloth; decal setting solution such as Micro Set or Micro Sol.What else you\'ll need to fly this model:
Electronic launch system; launch pad with Micro Maxx™ size launch rod; recovery wadding; Micro Maxx™ engines.