THE KEEP: cooling stand for the Valve Steam Machine
The Steam Machine takes its cooling air in from underneath, and sat flat on a desk there is barely any gap for it to pull through. The Keep lifts it 51 mm and leaves an open chamber below.
Pick your colour from the dropdown above.
What it is
A castle. Square wall on a sloped footing, four hollow towers at the corners, an arched gate at the front, arrow loops down every side and courses of masonry cut into the walls. Battlements along both side walls. No logos, no lights.
Every one of those openings goes clean through, so air comes in from all four sides and feeds a hollow chamber that runs straight up to the machine\'s intake.
It just drops in
No screws, no clamps, no glue, nothing to assemble. The machine sits down into a shallow recess and rests on a ledge inside, held by its own weight. Lift it straight back out whenever you want.
The front and back walls are kept low on purpose, so the power button, USB ports, card slot and light bar all stay clear, and your cables have a clear run out of the back.
Specs
- 219 x 226 mm on the desk, 68 mm tall
- Lifts the machine 51 mm
- PLA, matte finish
- Approx. 175 g
- Fits the Valve Steam Machine (2026)
Matching faceplate
There is a Keep faceplate for the front of the machine: the gatehouse rising behind this wall, with drum towers, a portcullis over the gate, a shield of crossed keys and ivy climbing the stone, in black. It is listed on its own, and as a set with a black Keep for less than the two bought separately. Look for \"The Keep\" in my other items.
In the box
One Keep. The Steam Machine is not included.
Printed to order, one at a time, so you will see faint layer lines on it. On this one they run in with the masonry courses.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.