THE KEEP: faceplate for the Valve Steam Machine
A carved castle front for the Steam Machine. It goes on where Valve\'s plate goes, held by magnets, and comes off again in a second.
What it is
The gatehouse of a castle, in relief. Two round towers stand at the ends with a stone curtain wall between them, built of rough, weathered blocks with cracks running through them. In the middle a round arch holds a portcullis, half raised over a studded door. Above the arch hangs a shield with two crossed keys, between two banners, under a row of battlements. Arrow slits run down the wall and both towers, and ivy has climbed the stone left of the gate.
It is printed in black, so every stone, slit and leaf is drawn in shadow.
It matches the Keep stand
The Keep stand is the outer wall and its gate, and this plate is the gatehouse rising behind it, with its own gate directly above the stand\'s. The stand is listed on its own, and the stand and faceplate are also sold together as a set, for less than the two bought separately. Look for \"The Keep\" in my other items.
Fitting it
Pull the stock faceplate off the front of the machine. Press this one on in its place: four stacks of two magnets sealed inside the plate meet the four steel points the machine\'s own plate uses. No tools, no glue, nothing to modify. The USB ports, card slot, power button and light bar below it stay clear.
Specs
- 156 x 126 mm, the size of Valve\'s plate
- The towers stand about 14 mm proud of the plate
- PLA, black
- Eight 8 x 3 mm magnets (two stacked at each corner), sealed inside during the print
- Fits the Valve Steam Machine (2026)
In the box
One faceplate. The Steam Machine and the stand are not included.
Printed to order, one at a time, so you will see faint layer lines. Dust it with a soft brush.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.