THE KEEP SET: cooling stand and matching faceplate for the Valve Steam Machine
The Keep stand and its faceplate together, for less than the two bought separately, both printed in black. The stand lifts the machine 51 mm so its intake can breathe, and the faceplate puts the castle\'s gatehouse on the front of the machine.
The stand
A castle. Square wall on a sloped footing, four hollow towers at the corners, an arched gate at the front, arrow loops down every side and courses of masonry cut into the walls, with battlements along both side walls. Every opening goes clean through, so air comes in from all four sides and feeds a hollow chamber that runs straight up to the machine\'s intake.
The machine sits down into a 3 mm recess and rests on a ledge inside, held by its own weight. No screws or clamps.
The faceplate
The gatehouse rising behind the stand\'s wall. Two round towers, a weathered stone curtain, a portcullis half raised over a studded door, a shield of crossed keys between two banners, and ivy climbing the stone.
It goes on where Valve\'s plate goes: pull the stock plate off and press this one on. Four stacks of two magnets sealed inside it meet the machine\'s own four steel points. No tools, nothing to modify.
Specs
- Stand: 219 x 226 mm on the desk, 68 mm tall, lifts the machine 51 mm
- Faceplate: 156 x 126 mm, the size of Valve\'s plate
- PLA, black
- Fits the Valve Steam Machine (2026)
Only want one?
The stand and the faceplate are each listed on their own too. Look for \"The Keep\" in my other items.
In the box
One Keep stand and one Keep faceplate. The Steam Machine is not included.
Printed to order, one at a time, so you will see faint layer lines. Dust them with a soft brush.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.