iBlueControlMod Bluetooth Wireless Controller Internal Adapter PCB Board For PS1

iBlueControlMod Bluetooth Wireless Controller Internal Adapter PCB Board For PS1 Bluetooth Gamepad AdapterPCB

Note1: This kit can only be used with our Applications(iBlueControlMod config).

Note2: this kit not \'BlueRetro mod\'. BlueRetro APP can\'t use on this kit.

Don\'t upgrade \'BlueRetro firmware\' to this kit! Otherwise, this kit will be damaged.

Note：This kit does not include the plastic controller port!

Compatible adapter is a high speedBluetooth controller interface that opens retro consoles up to the plethora ofmodern controllers with latencies that even some wired adapters can\'t manage.
This new board allows for the use of up to 2connected Bluetooth controllers,
and can be mixed and matched with wired controllers on any of the ports forseamless to 2Bluetooth controllers can be paired at once.

Bluetooth Reset Button Usage:

The Bluetooth reset button on the console has beenconverted to offer new functionality based on how long you hold the buttondown. While it is being pressed the front ports will light up to show whichstate you will be enabling.

1.Holding for 0-3 seconds will test whether all 4 ports are working properly.

In this state all four front port LEDs will be solid on.

2.Holding for 4-6 seconds will disconnectall connected Bluetooth controllers

In this state all four front port LEDs willbe slowly blinking.

3.Holding for 7-9 seconds will enablepairing mode

In this state all four front port LEDs willbe blinking faster

4.Holding for 10 seconds or more willfactory reset to the original firmware and remove any custom configs.

In this state all four front port LEDs willbe blinking rapidly.

5. Hold reset button while powering on the iBlueControlModadapter will be in sleep mode and will not interfere with the console.

Use thisin the event that a peripheral is not working nicely with iBlueControlMod.

NOTE: Please pairing the wireless controller first if the wireless controller never pairing with this iBlueControlMod before.

--- Power off the PS1 console and then power on it again, willenable the pairing mode. (Or, Holding the reset button for 7-9 seconds will also enable pairing mode.)

Include:

1x iBlueControlMod adapter PCB for PS1 console.

1xSD Card (include iBlueControlMod Applications and manual.)