For Lippert 13398-D0 Dual Motor Synchronous Velocity Slide Controller V-Sync II

13398-DO Dual Synchronous Velocity Slide Controller, Replacement for Various in-Wall Slide-Outs Controller V-Sync II, Replaced 13398-C2 Version, Match 211852 Component

Product Description

• Fitment: 13398-DO slide controller for Sync II, suit for In-Wall Slide-Out on RV. The c2 controller has been discontinued and The DO is the upgraded version,replaced the 13398-C2
• Prevent leakage: The trailer manufacturer placed the controller on the floor, under a sink behind an invisible panel. Water can easily damage the original controller, leading to water leakage in the bathroom of the travel trailer. Replacing this original equipment and installing it on the wall can effectively prevent water leakage
• Direct replacement: Plug and play perfection, plugged in the controller and slide outs work perfect again
• Easy to display: The controller has 2 LED,1 green and 1 red, are provided to indicate current controller status and faults

• Note: Please confirm the model before purchasing,just need to remember to be very gentle with the reset button otherwise it comes off and cannot be reset

2*LEDs:

One green and one red, used to indicate the current controller status and faults.

Note:

Please confirm whether the model is suitable before buying.

FAULT INDICATION:

GREEN LED:

1BLINK =MOTOR 1

2 BLINKS = MOTOR 2

RED LED:

2 BLINKS=Battery dropout=Battery capacity low enough to drop below 6 volts while running or short in switch wiring.

3 BLINKS=Low battery=Voltage below 8 volts at start of cycle.

4 BLINKS=High battery=Voltage greater than 18 volts.

5 BLINKS=Excessive motor current=High amperage, also indicated by1 side of slide continually stalling.

6 BLINKS=Motor short circuit=Motor or wiring to motor has shorted out.

8 BLINKS=Wire short between controller and motor=Encoder is not providing a signal .This is usually a wiring problem.

9 BLINKS=Hall power short To ground=Power to encoder has been shorted to ground.This is usually a wiring problem.

On Jul 20, 2026 at 23:29:27 PDT, seller added the following information: