|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
AllScan UCI145 USB Communications Interface AllStar EchoLink Radio-less Node PTT
$109.00

AllScan UCI145 USB Communications InterfaceAllStar EchoLink DVSwitch Radio-less Node Audio/PTT Interface Module The AllScan UCI145 USB Communications Interface is a professional-grade yet low cost USB Audio+PTT communications interface for use with AllStar, EchoLink, SDR, remote rig control, and Radio-Over-IP (ROIP) applications. These are designed and optimized for use with communications microphones, speakers and other audio equipment, and are not intended to directly connect to radio transmitters or receivers.Features - Compact radio-less interface supporting RJ45 mics, 2.5W audio amp, 3.5mm TS Speaker Out and TRS Line Out
- Supports Mic PTT routing to CM108 COS or to integrated USB-UART CTS or DCD for broad application compatibility
- Mic Up/Down buttons connect to the UART RI/DSR lines to support application parameter adjustments / GUI control
- Mic Gain Adjust and Mic Boost controls provide a 50dB gain adjustment range supporting a wide range of communications microphones and dynamic mics. An internal 10Ω–0.5mF filter on the analog power supply ensures the lowest possible noise, particularly with older preamplified mics that do not have good supply voltage filtering or mics that combine audio and power on one line
- Switch selectable 200Hz & 3.5KHz 12dB/octave mic audio highpass and bandpass filters
- 6dB/octave bandpass filter ahead of the AGC mic preamp, and 6dB/octave highpass filter ahead of the speaker amp reduce ADC clipping and AGC gain-pumping, and minimize thumps, clicks and other background noise. These filters have a smooth response curve supporting extended frequency response for other audio applications
- Insert I/O jack supports additional mic audio processing, mixers, other audio systems or line level Aux In. 3.5mm Tip=Send (from AGC out), Ring=Return (to ADC in), Sleeve=Ground
- Thru-hole pads on PCB provide easy access to nearly all CM108 and UART I/O lines
- Comprehensive LED status indicators for USB host status, Mic PTT, Mic Signal & Clip, and RX (USB Host PTT). The signal and clip LEDs make it quick and easy to set mic input levels and minimize any risk of ADC clipping
- 3.5mm Line Out jack supports stereo TRS line out. The Line Out jack can also drive stereo headphones or headsets
- Extruded aluminum enclosure with ferrite and bypass cap filtering on all I/Os maximizes durability and EMI/RFI resistance. Optimized PCB layout with separate analog and digital power supplies and ground planes ensures extremely low noise and clear audio
- User-configurable TRRS jack can be connected to any internal header lines. For example a headset can be supported on the User I/O jack by connecting the Rx Audio (TxL), Mic Audio, and PTTIN lines
- Works as a standard USB audio interface on Win, Mac & Linux in addition to fully supporting AllStarLink, Ampersand-ASL, HamVOIP, DVSwitch, EchoLink, Zello and numerous ROIP, SDR, and remote rig control apps.Supports full-duplex audio with no dependence on PTT or COS
- Integrated High-speed USB 2.0 Hub provides 2 USB-C downstream jacks for other USB accessories, making your setup even more space efficient
OverviewThe UCI145 works with all known PC and smartphone OS's and ROIP / SDR / remote rig control applications, providing a professional-grade interface to amateur and commercial radio communications microphones and speakers. Because the UCI145 does not connect to a radio, no PTT output is needed from the USB host application. The UCI speaker output is always active and supports full-duplex communication.AllScan UCI's are inexpensive, compact and portable, and deliver excellent audio quality and dynamics. Note however that a high-quality microphone is essential. See theProductspage for a detailed list of mic recommendations. The UCI145 is designed specifically for Alinco RJ45 mics, but can also support Yaesu RJ45 mics or any dynamic or electret mic that will run from 5VDC. 49% smaller than the UCI120 but with more features. Integrates a USB-UART IC supporting all OS's and ROIP / SDR / remote rig control apps, 3.5mm Insert I/O jack, User Configurable 3.5mm TRRS jack supporting any internal CM108 and UART serial/GPIO header lines, 3.5mm Stereo TRS Line Out jack, switchable 12dB/octave Mic Band-Pass or High-Pass Filter, 4 tri-color status LEDs, and a Hi-Speed USB 2.0 hub with 2 USB-C downstream jacks. The UCI145 is a simplified version of the UCI150 that supports only Alinco RJ45 and compatible mics. Alinco mic Up/Down buttons connect to the UART RI/DSR lines for application/GUI control capability. 2.9" x 1.1" x 3.2" extruded aluminum enclosure. See the UCI145Product Pagefor more information. Radio-less Node Benefits - Radio-less nodes are ideal for use cases where WiFi or wired ethernet are available but the additional range provided by an HT or mobile radio is not needed, such as for a desk or table at your home QTH / office / shack, for vehicles or RVs where you have a WiFi hotspot, and for 2nd offices, hotels, etc. Radio-less nodes are the simplest, easiest and most cost-effective way to get on AllStar with your own node, and are more portable than even the smallest radio-based node and radio needed to access it.
- For a node that's sitting a few feet away on a desk it makes more sense to use a radioless node than to have multiple radios on transmitting 100's of milliWatts of RF. Radio-less nodes are more energy efficient, using generally less than a few Watts, vs. a node with radios plus other radio(s) to access it is easily 3 times the energy consumption.
- Radio-less nodes also support Full-Duplex by default. This is a powerful feature, and makes a properly designed radio-less node much nicer to use than any half-duplex node.
Includes a fully assembled & tested unit and short USB-A to USB-C cable, ready to plug into any MiniPC or RPi / Linux SBC running ASL, HamVOIP, DVSwitch, or any PTT communications, SDR or remote rig control app. The UCI145 is also available in packages with a Genuine Alinco EMS-79 DTMF hand mic, or with an EMS-79 and QWork 8Ω 5 Watt speaker.Most orders ship within 1 business day. 73, NR9V

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|