ZXM-32 Taper Tension Controller Automatic Manual Magnetic Particle Motor Control
$100.32

ZXM-32 pulse type taper tension controller
Shipping quantity: 1pcInput voltage: AC220V±15%Output current: DC0-3A◆Maximum output current setting: 2A/3AAdapted load impedance: 8-12QCurrent output fluctuation: <0.01A◆Tension control method: manual control/pulse taper control◆Taper mode selection: rewinding taper/unwinding taper◆Pulse setting range: 0-999 times◆Maximum frequency of pulse input: 100HZ
Tip: 0-5V tension signal output can be used to drive tension plates or torque motors, etc., when usedWhen using this signal, the system parameter P11 needs to be set to 3A, otherwise the maximum output voltage willCan\'t reach 5V.Note: 0 The working voltage of this controller is AC220V±15%/50-60HZ. If the voltage is too high, it willCause permanent damage to the controller.The impedance of the magnetic powder clutch brake should be between 8-12Q, otherwise it may cause controlThe device may overheat and be permanently damaged.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.