This sale is for 4inch RPi LCD (A) 4 inch Touch Screen TFT LCD Designed for Raspberry Pi. Features
- Designed for Raspberry Pi, an ideal alternative solution for HDMI monitor
- Supports any revision of Raspberry Pi (directly-pluggable)
- Drivers provided (works with your own Raspbian/Ubuntu directly)
- IPS technology, high quality and perfect displaying from very wide viewing angle
- 320×480 resolution
- Convenient Men-Machine interface for Raspberry Pi, combined with the portable power, DIY anywhere anytime
- Supports Raspbian system, enables your system to:
- Take photos by touching (up to 17 camera modes)
- Support software keyboard (system interaction without keyboard/mouse)
Key Parameters LCD TypeTFTLCD InterfaceSPITouch Screen TypeResistiveTouch Screen (Pixel)Aspect Ratio8:5Power ConsumptionTBDBacklight CurrentTBDOperating Temp. (℃)TBDPhotos
PIN NO.SYMBOLDESCRIPTION1, 173.3VPower positive (3.3V power input)2, 45VPower positive (5V power input)3, 5, 7, 8, 10, 12, 13, 15, 16NCNC6, 9, 14, 20, 25GNDGround11TP_IRQTouch Panel interrupt, low level while the Touch Panel detects touching18LCD_RSInstruction/Data Register selection19LCD_SI / TP_SISPI data input of LCD/Touch Panel21TP_SOSPI data output of Touch Panel22RSTReset23LCD_SCK / TP_SCKSPI clock of LCD/Touch Panel24LCD_CSLCD chip selection, low active26TP_CSTouch Panel chip selection, low active
Package Contains
- 4inch RPi LCD (A) x 1
- Touch pen x 1
- RPi screws pack (2pcs) x 1
- DVD × 1
FAQ Why the LCD doesn\'t work with my Raspbian? To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual.
However, for the first testing, you may want to use our provided image directly. Why the LCD still doesn\'t work with the Waveshare provided image? Make sure the hardware connection is correct and connects fine.
Make sure the image in TF card is burnt correctly.
The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact. Which power supply should I use? It is strongly recommended to use a stand-alone 5V/2A power adapter, because the PC\'s USB port might have not enough power to support the Pi and LCD.
For more info, please check the wiki page.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.