WS2812B 1010 LED Strip - Tiny & Flexible

[Here is the source provider for this product, you are welcome to drop us a message if you want customized length or large amount of strip]
The narrowest and highest-density flexible RGB LED strip, which can be used as DIY accessories for RC models, scale models, Gundam plastic models, etc.The strip can be cut at any position - without the need to remove a LED ahead; or cut at odd or even positions.
Specification

• LED type - WS2812B 1010
• LED size - 1mm * 1mm * 0.8mm
• Strip length - 60mm / 100m / 200m
• Strip width - 1.8mm
• Strip thickness - 0.82mm
• Distance between LEDs - 0.6 ~ 0.7mm
• Strip material - FPC
• Rated Voltage - 5V DC
• Pre-soldered wires (enameled wire) - 100mm

Available in 3 different lengths

• 60mm, 34 LEDs (Total length of the LEDs from end to end is approximately 59mm)
• 100mm, 56 LEDs (Total length of the LEDs from end to end is approximately 97.3mm)
• 200mm, 112 LEDs (Total length of the LEDs from end to end is approximately measurements are prone to slight discrepancies for above size.
• The LED strip needs to be driven by a WS2812/WS2812B driver (which you need to prepare by yourself).
• The colors and lighting patterns of the LEDs are controlled by connecting the signal pole, it will not light up just by connecting the positive (V) and negative (G) poles.
• Items other than LED stripes in the demo are not waterproof
• Avoid sharp bends – flexible but not foldable
• Handle gently – no tugging
• The LED strip has a rated voltage of 5V. If excessive heating is observed under the rated voltage, connect a 10~20 ohm resistor in series with either the positive (V+) or negative (GND) power supply terminal to mitigate thermal issues.