Ready to handle any environment, the SPARC features tough construction with a compact and lightweight form-factor. The 2 MOA dot is as easy as point and shoot—it’s quick to acquire in close-quarters scenarios, but fine enough to promote pin-point accuracy at extended ranges. A unique, integrated base is hassle-free for some rifle platforms. For excellent, reliable performance and loads of user-friendly features, look no further than the SPARC.
Included:
- Rubber Cover with Flip-Up Lens Caps
- AAA battery
- T10 Torx wrench
- Multi-height mount system
Daylight Bright Red Dot Reticle
The daylight bright 2 MOA dot is fast and easy to use. Choose among ten variable illumination settings—the lowest two settings are night-vision compatible.
The key thing to remember when shooting with the SPARC Red Dot is to keep both of your eyes open! Shooting with both eyes open allows you to take full advantage of your peripheral vision to get on target very quickly. Eye placement is not critical.
Windage and Elevation Adjustments
The SPARC red dot incorporates elevation and windage dials with audible clicks. Each small click will move the point-of-impact one Minute of Angle (MOA). 1 MOA will closely correspond to one inch at 100 yards, 1/2 inch at 50 yards, 1/4 inch at 25 yards, etc.
Elevation Adjustment
Remove the turret cap and turn the inner screw counter-clockwise to adjust the bullet’s point-of-impact up; turn the inner screw clockwise to adjust bullet’s point-of-impact down.
Windage Adjustment
Remove the turret cap and turn the inner screw counter-clockwise to adjust the bullet’s point-of-impact to the right; turn the inner screw clockwise to adjust windage bullet’s point-of-impact to the left.
Mounting the SPARC Red Dot
The SPARC Red Dot can be mounted at two heights, lower 1/3 co-witness and absolute co-witness. To mount it at lower 1/3, mount the sight as received. The optic center will be 40mm above the base surface. To mount for absolute co-witness you can remove the 3mm base shim. The optic center at absolute co-witness will be 37mm above the base surface. To change the mount height, loosen and remove the four base screws and remove the base clamp along with the 3mm shim. Reinstall the base clamp with the four shorter screws supplied with your Red Dot.
Vortex Sparc Red Dot SpecificationsMount Lens Diameter22 mmDot ColorBright RedDot Size2 MOAEye ReliefUnlimitedAdjustment Graduation1 MOAMax Elevation Adjustment90 MOAMax Windage Adjustment90 MOAParallax SettingParallax FreeLength2.9 inchesWeight7.5 ozFREE SHIPPING FOR LOWER 48 STATES ONLY, ALL OTHERS MUST CONTACT US FOR SHIPPING RATES *(HI, AK, APO ETC)
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.