|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Universal Black Motorcycle Subframe Guards | Dirt Bike Frame Protection
$15.00

Includes - 2 Sub Frame Guard Strips (Cut to length)
What Do They Do? - Protects the coating or metal on your sub frame
- Adds grip
- Covers up worn looking sub frames
- Gives your bike a clean look
What Are They? Thesearethick vinyl protectors that have a very strong adhesive backing.Theyapply easilybutdon\'t add bulk to your frame. These are not made from sandpaper type material, so they will not wear down your boots and riding gear. Guards are a universal fit, you will need to trim them to length for your particular bike. Protecting your sub frame with guards is much cheaper and easier than refinishing your frame every few months due to wear and tear on the coatings/metal. Specs - Each strip is 10\" x 2\"
- Made from the thickest material on the market
- Extreme high adhesion allows guards to stay in place
- Textured finish provides grip between rider and bike
- Adheres to aluminum, steel, plastic, powder coat, and cerakote
- Should not be applied over spray painted surfaces
- 100% made in the USA!
How To Install Guards / Decals Getting Started - Have a heat gun or hair dryer on hand.
- Do not use any type of water, windex, or soap solution for installation.
- Install guards in a warm area to help them adhere and conform better.
Guard Installation - Remove any glue, dirt, or grease from part.
- Clean part surface with isopropyl alcohol or contact cleaner, and let dry.
- Use a heat gun or hair dryer to warm up the surface and guard if temperature is below 60F.
- Peel part of the paper backing away, and line up guard at the most detailed part.
- Be sure not to touch the part surface or adhesive with your bare hands.
- Once you are happy with the alignment, tack the guard down at the center and work your way from the center towards the edges.
- If the guard is off center or an air bubble starts to form, you can carefully peel up the guard to correct.
- As you get to the edges and tighter spots, creases may start to form. Add a small amount of heat to stretch the guard so it lays flat.
- Do not apply excessive heat, as this may melt the guard.
- If your part has tight crevices, use a soft rubber or plastic edge to help press the guard into those spots.
- Once the guard is fully tacked in place, heat the guard again while applying pressure. This is very important to the adhesion of the guard, so make sure you don\'t skip this step.
Getting The Most Out Of Your Guards - When installing the guard, make 100% sure the surface is clean and the edges are not hanging off the part.
- It is not recommended to use boots with steel toe caps, as this will wear out guards much quicker.
- If you notice an edge start to peel up, apply heat and tack it back down or lightly trim the edge.
- If using a pressure washer to clean your bike, take caution around the guards.
Removing Old Guards - Before removing a worn guard, apply heat to help soften up the adhesive, this will also prevent adhesive from being left behind.
- If adhesive is left afterwards, tack the old guard over the adhesive and this will help peel it up. Use a contact cleaner or isopropyl alcohol to remove any leftover adhesive.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|