UV Solar Shield Display Cover for Jandy TruClear / Pro Series
$49.99

I\'m Mark with Zen Frog Pools in Port St. Lucie, Florida. I work on pool equipment for a living, and I\'ve seen plenty of TruClear displays get wrecked by sun, rain, and sprinkler spray. I designed this UV Solar Shield Display Cover myself and I 3D-print it here in black ASA, which holds up to UV and heat outside.
It\'s made specifically for Jandy TruClear / Pro Series salt chlorinator control panels. Not for Hayward or AquaPure units. The frame goes around the display. The door opens to the side so you can use the screen and buttons, then snaps shut on two pegs. The hinge is printed in place on the left — no separate pins. There\'s a finger tab on the right, and angled louvers near the bottom so it can stay closed without trapping a lot of heat.
No drilling and no screws. The outdoor tape is already on the back. You just peel off the plastic liner. I\'ve installed one on a real TruClear. The photos show it open and closed.
This is a cover, not a sealed waterproof box. It keeps sun, rain, and sprinkler water off the display and keypad.
In the box- 1 UV Solar Shield Display Cover for Jandy TruClear / Pro Series, with outdoor mounting tape already on the back- 1 alcohol prep pad
The details- Printed in black ASA (acrylonitrile styrene acrylate) — holds up to UV and heat- Made specifically for Jandy TruClear / Pro Series salt chlorinator control panels- Not for Hayward or AquaPure units- Frame: 102.6 x 159 mm (about 4.04 x 6.26 in)- Window: 71.8 x 128.2 mm (about 2.83 x 5.05 in), so the screen and buttons show through when the door is open- Weight: about 38 g- Print-in-place pin hinge (no separate pins)- Two snap pegs and a finger tab- Angled downward louvers near the bottom- Made in the USA, in Port St. Lucie, Florida
Putting it on1. Hold the frame up to the display first, before you peel the liner.2. Clean the area with the alcohol prep pad I include, and let it dry.3. Peel the plastic liner off the tape on the back of the cover. You don\'t need any extra tape.4. Line it up so the screen and buttons show through the window, with the hinge on the left side of the display.5. Press it on firmly for 30 seconds.6. Give the tape a day to set before you tug on the door or get the area wet.7. Open it with the finger tab. It snaps shut on the two pegs.
DisclaimerThis is an aftermarket part. It is not made by, affiliated with, or endorsed by Jandy, Zodiac, or Fluidra. \"Jandy,\" \"TruClear,\" \"Pro Series,\" and \"Zodiac\" are trademarks of their respective owners and are used only to describe compatibility.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.