Two-Node RS485 Parts Kit 2 UNO-Compatible Boards 2 Waveshare 5V Modules
Learn wired sender/receiver or master/slave communication with two programmable endpoints.
Included
Two aftermarket UNO R3-compatible CH340G boards, two 30cm USB cables and two Waveshare 5V UART-to-RS485 transceiver boards.
Build requirements
Provide twisted-pair bus cable, jumper wires, suitable power connections, termination/biasing and firmware. Configure UART and driver/receiver enable on each side. The transceiver modular jacks are not Ethernet ports. No isolation or preinstalled Modbus application is included. Both aftermarket controllers are compatible with Arduino UNO R3; Arduino is not their manufacturer.
Components are supplied separately and require assembly and programming. Component photos may be shown at different scales. Demonstration graphics are not a promise of installed software.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.