Genuine Trimble UX5 eBox flight-control / avionics module removed from a professional aerial imaging UAV.
The eBox is the removable electronics module used by the Trimble UX5 aircraft and houses the primary flight-control and avionics electronics used to operate the aircraft.
Trimble documentation identifies the eBox as the computer that controls the UX5 and interfaces with the aircraft GPS and radio antennas for navigation and ground-station communication.
This unit was removed from an impact-damaged Trimble UX5 aircraft and has not been powered or functionally tested following UX5 eBox flight-control / avionics module
Integrated avionics and electronics
External connectors / interface hardware
Components exactly as shown in the photos
Please review all photos carefully for exact configuration, connector condition, antenna interfaces, cosmetic condition, labeling, and included components.
This assembly is being sold AS-IS in unknown operational condition.
No representation of serviceability, software / firmware status, calibration, operational suitability, or airworthiness is being made.
Buyer is responsible for inspection, testing, configuration, software compatibility, and determining suitability prior to installation or use.
Shipping:
FREE UPS Ground shipping within the contiguous United States.
Expedited UPS shipping services are available upon request at additional cost.
Professionally packaged and shipped by Midwest Aerial Supply.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.