Trim Router Holder – Compatible with Bosch GKF 12V-8, Black

• BENCH SPACE BACK — When your trim router is sitting where your next board needs to go, move its storage to the wall. This holder keeps your trim router off the work surface and accessible between tasks, so your bench stays available for laying out stock, measuring a cut, or setting down the piece you are working on instead of becoming a parking spot for your trim router.
• SLIDE IN STORAGE — Put your trim router away with a straightforward sliding motion instead of leaving it on the bench after a cut. The slide-in holder gives you a clear place to return your trim router between tasks, whether you are pausing to check your work or clearing up at the end of a workshop session; putting it away becomes part of finishing the job rather than another thing to sort out.
• KEEP YOUR SETUP — Leave the router bit fitted when you put your trim router away, rather than removing it just to make room for storage. When a project pauses for marking, measuring, or another task, your trim router goes into its wall holder with the bit still attached, so putting it aside does not add an unnecessary bit-removal step to the work you have already done.
• PLAN YOUR WALL — Choose a spot in your workshop where your trim router belongs between jobs, then plan the attachment around the holder\'s three mounting holes. Those three attachment points give you a defined layout for placing the holder on your wall, whether your work area is centered on a woodworking bench or a smaller surface that needs to stay clear for the next task.
• GET READY TO MOUNT — Match the attachment to the holder before you start organizing your work area: this plastic part mounts with 4 mm countersunk screws. WHAT\'S IN THE BOX — Only the item named in the title. No hardware is included (see the description).

Your trim router is taking up bench space you need for your next piece of work. Leaving it on the work surface also means moving it again when it is time to measure, mark, or lay out a board.

This wall-mounted trim router holder moves that storage onto your workshop wall. Your trim router slides into the holder between tasks, leaving the work surface free while keeping it accessible for the next cut. Instead of finding another spot on the bench each time you pause, you have a clear place to put it away.

The router bit stays fitted during storage. There is no need to remove it just to put your trim router in the holder, so a pause in your project does not turn into an extra bit-removal task. Finish a pass, slide your trim router into its wall storage, and use the open bench for the next stage of your work. When you return to routing, the bit is still attached.

For woodworkers and other trim-router users, this is a straightforward way to organize a workshop or work area around the work itself. Put the holder near your bench for access between cuts, or use it as your trim router\'s regular storage spot when you clear up after a session. The benefit is especially clear when your work surface has to serve several jobs: your trim router belongs on the wall rather than in the space needed for the next one.

The holder is a plastic part with three mounting holes intended for 4 mm countersunk screws. Plan its position on your wall around those attachment points, mount the holder, then slide your trim router into place.

HARDWARE NOT INCLUDED: Only the item named in the title is in the box. Every setup is different: depending on yours, mounting it or attaching it to an existing part may use hardware you already have, such as the original screws, or you may need to buy your own screws, bolts, tape or adhesive to suit your situation. No hardware of any kind is included with this listing.