|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Total Control Products Subframe Connector System Coupe/ Fastback Mustang 65-7...
$981.99

When looking to stiffen up your 1965-1970 Mustang\'s chassis, look no further than Total Control Products\' Subframe Connector System Package. The package includes a pair of weld-on subframe connectors, a bolt-on center support and a bolt-on driveshaft safety loop.
Features: - 2\" x 2\" x .083\" boxed tubing subframe connectors - 1-5/8\" x .134\" round tubing center support - Tightly follows undercarriage sheet metal - Fully sealed construction - 5-1/2\" diameter driveshaft loop - Black powder coat finish - Room for 3\" dual exhaust
Subframe connectors strengthen the unibody by connecting the front frame rails to the rear frame rails. 2\" x 2\" x .083\" boxed tubing is fully sealed with 7 gauge formed sheet metal mounts. Front and rear mounts are placed to weld at the strongest points of the factory subframe. Mounting holes are pre-drilled for simple installation of the TCP center support.
Tying the subframe connectors together is a bolt-on center support constructed from 1-5/8\" x .134\" round tubing. This diagonal cross brace is held on with grade 8 hardware. Four 7 gauge mounts are slotted to allow for chassis variances. A shim set is included to achieve a perfect fit every time. The support is angled, sitting 1-1/2\" below the forward factory subframe at its lowest point to allow for added exhaust clearance.
The center support has a mounting plate to attach the included safety loop. Both the mounting tab and bracket are constructed from 1/4\" thick mild steel and secured with grade 8 fasteners. The driveshaft loop has a 5-1/2\" inner diameter and 2\" depth. Loop adjustment comes from slotted holes at each of the attachment points to account for various transmission lengths and driveshaft angles (1/2\" vertical, 3/8\" horizontal, 3-5/16\" fore/aft).
All parts are powder coated black and all necessary hardware is included.
Kit Includes: - Pair of weld-on subframe connectors - Bolt-on center support - Driveshaft safety loop
Please Note: Custom exhaust may be required. There is room to tightly run 3\" dual exhaust.
*The center support has a mounting bracket for a TCP standard 33\" length torque arm.
OTHER APPLICATIONSFits 1967-1970 Mercury Cougar (Hardtop)

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|