Sansui 2000A Complete Rebuild Kit High-Quality Receiver Recap Transistors
$100.00

Up for sale here is this rebuild kit for the Sansui 2000A receiver. This includes all the parts you need to rebuild a Sansui 2000A, and includes the correct size replacement main filter capacitors. This does not include new lights or fuses. This also does not include the driver or output transistors. Correct replacement outputs are four MJ21196G, availablehere.Please don\'t buy any of the Chinese transistors on --those are counterfeit and can blow up.
This kit includes replacements for all the electrolytic capacitors in the receiver, including the four large chassis-mount capacitors, which are replaced with three new Epcos or Nichicon LS 3300 uf 100v caps and one Chemi-Con 1200 uf 80vcap.The new caps are the same diameter as the old ones so they will fit the old clamps perfectly. The kit also includes replacements for almost all the transistors on all the boards except the tuner board. Transistors frequently age worse than the capacitors, so you have to replace them when you\'re doing a rebuild. Replacements for the driver board trimmers and a number of diodes are also included.
This kit also includes two capacitors and two resistors to apply some of the \"Conrad mods\" to the driver board.
These are all high-quality brand new genuineparts, the same ones I use when I rebuild vintage equipment. Capacitors are Nichicon PW, Panasonic FC, TDK film, Wima film, 4 Supertech axial caps, 2 Supertech radial caps, 2 Kemet safety disc caps, and 4 Epcos/Nichicon LS/Chemi-con snap-in caps. Transistors and diodes are Onsemi and Toshiba.
This kit includes a total of 103 parts. The parts for each board are individually bagged for ease of installation, and the instructions will tell you how the transistors and diodes go in, but there are a LOT of parts to replace here, so if you do not have a lot of experience with vintage gear I would not recommend starting with this one. You should know what you\'re doing and have a decent soldering iron, heat-sink compound, and a dim-bulb tester with 40W, 60W, or 100W incandescent bulb. I would recommend a a desoldering gun such as a Hakko FR-301, but it\'s not absolutely necessary.
Looking for more parts? I have power switches, feet, pushbuttons,top case screws, bottom screws, faceplate screws, white LED fuse lamps, blue LED fuse lamps, 6.3v bi-pin bulbs, 8v bi-pin bulbs, 12v bi-pin bulbs, wired 8v 60ma bulbs, new power cords, new main capacitors for the Marantz 1060/2230, wired Pioneer speaker plug replacements, new 630v yellow film capacitors at 38 different values, new 1200v yellow film capacitors at 15 values, a large variety of transistors for vintage stereo repair, new Wima film capacitors for stereo repair, new 250v yellow film crossover capacitors, and more. Just use \"add to cart\" on everything you want and then check out for combined shipping.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.