STLINK-V3SET Modular Debugger & Programmer for STM32/STM8 USB 2.0 Interface

DESCRIPTION
STLINK-V3SET, Modular In-Circuit Debugger And Programmer For STM32/STM8STLINK-V3SET Debugger/Programmer

Suitable for STM8 / STM32 microcontrollers

The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

Features At A Glance

• Stand-alone probe with modular extensions
• Self-powered through a Micro-B USB connector (does not provide power supply to the target application)
• USB 2.0 high-speed compatible interface
• Direct firmware update (DFU) support, to use with more future devices
• Supports JTAG / SWD interfaces, 3V~3.6V application voltage support and 5 V tolerant inputs
• Supports SWIM interface, 1.65V~5.5V application voltage support, only available with adapter board MB1440
• Virtual COM port (VCP) specific features:
  • 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
  • VCP frequency up to 15 MHz
  • Available on STDC14 debug connector (not available on MIPI10)
• Drag-and-drop Flash programming
• Two color LEDs: communication, power

Software Support
Hardware Support

All STM32 MCUs With JTAG / SWD Interface

All STM8 MCUs With SWIM Interface

• for reference only, the STM32 and STM8 boards above are NOT included
• JP4 and JP6 jumper caps must be connected to use the SWIM interface

Product Assembly Diagram
STLINK Series Selection GuideITEMV3MINIEV3SETV2JTAG/SWD APPLICATION APPLICATION VOLTAGEN/A1.65V~5.5V1.65V~5.5VSWV SUPPORTYES②DEBUG INTERFACEmultimulti③2LED INDICATORtwo colors④① ST-LINK/V2 and STLINK-V3MINIE support STM32 low-power devices.
② Only available for STM32 at present.
③ STLINK-V3SET features GPIO port besides the programming port.
④ Two colors LED indicates both power and communication.
What\'s On Board

1. Micro USB port
2. Power LED indicator
3. COM LED indicator
   COM LED is blinking RED: the first USB enumeration with the PC is taking place.
   COM LED is RED: communication between STLINK-V3SET and the PC is established (end of enumeration).
   COM LED is blinking GREEN/RED: data are being exchanged between the target and the PC.
4. UART header (VCP)
5. SWIM header
6. SWD header

1. SWIM ON/OFF
   enabled when jumper cap is connected
2. CAN header
3. CAN ON/OFF
   enabled when jumper cap is connected
4. UART Bridge
5. SPI/UART/I2C/CAN/GPIOs Bridge
6. SPI Bridge
7. JTAG20 header
8. STDC14 header

Product Show

Outline Dimensions
Resources & Services
PACKAGE CONTENT

Weight:0.23 kg

STLINK-V3SET x1