Router Table Insert Plate Levelers for Kreg Precision Router Table Insert Plate

• SMOOTHER WORKPIECE TRAVEL — Keep your work moving across your router table instead of catching at the insert plate edge. These levelers support the insert and bring its surface flush with the surrounding tabletop, giving your boards a level path across the plate opening so your attention stays on guiding the workpiece rather than navigating a raised edge during each routing pass.
• CORNER AND SIDE CONTROL — Fine-tune the insert plate in your router table at its sides as well as its corners for more precise alignment with the tabletop. The corner and side mounting arrangement provides adjustment points around the plate opening, so you address the side edges along with the corners as part of the same leveling job before bringing your workpiece to the table.
• MOUNT TO YOUR TABLE — Position the levelers around the insert opening in your router table and attach them with wood-screw mounting to establish the plate\'s leveling points. Needs 1 x M5 adjustment screw, 1 x M5 square nut, 1 x M6 plate mounting screw, 1 x M6 square nut and 1 x 4 mm wood screw; this hardware is not included and must be purchased separately.
• CONTROL YOUR PLATE HEIGHT — Correct an insert plate that sits above or below the surface of your router table with an M5 adjustment screw and matching M5 square nut. The screw-based adjustment lets you use the surrounding tabletop as your reference while you bring the plate to a flush height, putting the leveling step into your workshop setup before a workpiece reaches the insert opening.
• DEDICATED PLATE MOUNTING — Fasten the insert plate in your router table with an M6 plate mounting screw and matching M6 square nut, separate from the height-adjustment hardware. The plate mounts to the levelers, making attachment part of your table setup alongside leveling, so you have a defined mounting arrangement for the insert that forms the working surface at the table opening.

Bring the insert plate in your router table into line with the surface you work on. When the plate sits above the tabletop, its raised edge interrupts the path of your workpiece; when it sits too low, the working surface is no longer level. SplashNColor router table insert plate levelers support the insert and let you adjust its height flush with the surrounding tabletop, creating a level transition for boards moving across the opening.

The corner and side mounting arrangement brings more precise plate adjustment to your workshop. With adjustment points at the corners and along the sides, you address the plate\'s alignment in both areas as you establish a flush working surface. Check the transition between the insert and the surrounding tabletop as part of your setup, before bringing a board to your router table.

Mount the levelers to your router table with a 4 mm wood screw. An M5 adjustment screw and matching M5 square nut provide height adjustment, while an M6 plate mounting screw and matching M6 square nut fasten the insert plate to the levelers. The mounting and adjustment hardware serve different jobs, giving you a clear arrangement for attaching the levelers, positioning the plate and securing the insert.

Whether you are fitting an insert plate or correcting its height in your workshop, use the surrounding tabletop as your reference as you adjust. Bring the supported plate\'s top surface flush with the table around it, correcting a position that sits too high or too low.

Hardware needed (not included): 1 x M5 adjustment screw, 1 x M5 square nut, 1 x M6 plate mounting screw, 1 x M6 square nut, 1 x 4 mm wood screw. Screws, bolts, nuts, anchors, adhesive, adapters, cables and any other hardware are also not included, so buy what you need separately.