Rocketarium Flying Model Rocket Kit MIM-23 Hawk ROC RK-1047
Uses D or E Motors
Ejection Baffle (no wadding required)
Laser Cut Fins
3D-Printed Tail Cone
Plastic Parachute
Over 21\" Tall
Intermediate Assembly Skills Required
Recommended Engines (apogee ft):
C11-3 (250), D12-5 (600), E12-6 (950), 24E22-6 (820), 26E31-6 (890)
Length: 22.9\"(58.2cm)
Diameter: 1.64\"(42mm)
Estimated Weight without motors: 146g
3/16\" Launch Lugs
This is a model kit of MIM-23 HAWK surface-to-air missile. The kit comes with 24mm Motor Mount and Balsa fins and channels. We supplied pre-marked tubes, so kit is not difficult to build. This is an \"easy-to-paint\" model
Requires:
Motor, Igniter/starter
Launch Pad
Launch Controller
3/16\" Launch Rod
eBond Wood Glue
Sand Paper
Hobby Knife
Primer & Paint
Model Rocket Kits are rated by Skill Level
1 Beginner
2 Intermediate
3 Advanced
4 Expert
5 Master
If you are just starting in the hobby start at the beginner level and move up from there at your own pace.
What is needed to build and fly
All model rockets come in kit form that require assembly. The materials areprimarily cardboard tubes, balsa or plastic fins and nose cone. Materialswill vary by model and are typically specified in the description of each kit.
Additional supplies will be necessary to build and finish your model rocket kit and may include:
Scissors, Hobby Knife
Ruler
Wood Glue, Model Cement or CA(Super Glue)
Sandpaper
Masking Tape
FinishingSupplies like:
Wood Filler
Sealer/Primer
Paint
Launching Equipment and Supplies like:
Recovery wadding
Launch Pad
LaunchController
Power supply
Model Rocket Motors and Igniters
A safe place to fly using guidelines from the National Association of Rocketry Safety Code
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.