Polyaspartic (High Gloss)

Concrete Resurrection Polyaspartic is the ultimate solution for elevating the appearance and longevity of concrete, natural stone, and other cementitious surfaces. Engineered for exceptional performance, this innovative coating delivers a remarkably high gloss shine that not only enhances aesthetic appeal but also provides robust protection against harsh environmental conditions, including UV rays, freeze/thaw cycles, and hot tire pick-up.
What sets Polyaspartic apart is its quick curing capability, allowing for foot traffic within 3-4 hours and the ability to recoat in just 2-3 hours, all while achieving full cure within 24 hours. This efficiency means less downtime and more opportunities to maximize profit. The superior penetration and bonding strength ensure that it holds tight to the surface, resulting in fewer callbacks, making it a reliable choice for professionals.

The user-friendly two-component system simplifies the mixing process, and it can be applied conveniently at temperatures ranging from 40°F to 85°F. With a film build of up to 6 mil, the surface protection increases significantly, providing additional peace of mind. Whether for interior or exterior projects, Concrete Resurrection Polyaspartic adapts effortlessly, ensuring flexibility in scheduling.

As a high-quality product with 80% solids and only 250 g/l VOCs, it combines performance with environmental consciousness. However, safety precautions must be noted as the product is flammable. Upgrade your surfaces with confidence using Concrete Resurrection Polyaspartic, where durability meets sophistication.
Coverage:Coverage rate is 200-600sq ft per kit. Coverage variations depend on concrete surface porosity, application method and amount of material applied.
Surface Prep:The concrete surface must be deemed mechanically and structurally sound, completely clean, and dry. To achieve the above desired results, a mechanical grinding method should be performed to an approximate 50-100 grit profile to insure flatness of the substrate, to remove surface impurities, and to profile the surface of the floor to aCSP-2, as recommended by the ICRI Technical Guideline No. 03732. If mechanical means of preparation are not suitable, it is recommended to prepare the surface with Concrete Resurrection Surface Prep and Etch solution. The final rinse must contain a neutralizing agent.

MIXING: Proper mixing is pertinent to application success. In equal parts (1:1), mix Part A and Part B using a clean, dry mixing container. Stir contents approximately 30-60 seconds. Avoid over-mixing or creating a vortex which could introduce moisture content to the mixture. No induction time is required prior to use, nor after mixing. If integrating anti-skid media agents, only do so after Parts A & B have been thoroughly mixed.

POT LIFE: Expected workable pot life after mixing Part A and Part B is approximately 25-30 minutes at a common temperature range of 70 F-80 F at roughly 50% relative humidity. Higher temperatures and high percentages of humidity will shorten pot life, as colder temperatures and lower percentages of humidity will extend the coatings pot life.

Application:Application should be completed using a 3/8” synthetic nap, phenolic core roller, or a lambs’ wool cover for pigmented, stained floors, or media coats. Use a foam squeegee and back roll with the roller over media floors (quartz or chips). Please note that the use f pump-up style spray bottle may create visible bubbles, blisters, and pinholes and is not recommended.