PELCONET NET350T IP NETWORK VIDEO TRANSMITTER WITH COMPACTFLASH INTERFACE AND AUDIO
• Send and Receive Live Video, Audio, and Control Data Over Ethernet
Networks
• Dual MPEG-4 Video Streams
• CompactFlash ® Interface for Local Recording
• Full Integration with Pelco’s Matrices, Genex ® Multiplexers,
Spectra ® Domes, and Esprit ® Positioning Systems
• Adjustable Bandwidth, Image Rate, and Quality
• View Video on PC, Analog Monitor, or Both
• NTSC and PAL
• Alarm Input and Relay Output
• Two offerirectional Data Channels Via RS-232 and RS-232/422/485Serial PortsThe NET350 can be used in three ways:
•Standalone – as a transmitter or receiver for a camera where BNC
cable is not possible. This allows one-way video transmission for
fixed cameras or the option of sending control signals to a Spectra®
dome or Esprit® positioning system.
•Analog to Ethernet “Bridge” – as a way of using one or more
NET350s connected to a system of Pelco matrices or Genex® multi-
plexers to view video from a vast number of camera analog inputs.
In this application the analog device is being used as a “concentra-
tor” to allow viewing of hundreds of cameras without incurring the
cost of hundreds of encoders.
•Complete Ethernet System – as a way of controlling an unlimited
number of cameras via NET350s by using Pelco’s VMX series of
matrix control software in a purely Ethernet or hybrid system.
Ethernet systems involve using an encoder with each camera and
using the Ethernet as a virtual matrix. This is cost efficient for new
installations or add-ons to existing installations. Using the VMX300
as control software for existing systems as well as new Ethernet
portions allows the user to build the industry’s only truly “hybrid”
CCTV system.
The NET350 can display video on a PC using Internet Explorer® , an
analog monitor, or both.
PelcoNet™ transmits (NET350T) or receives (NET350R) live video,
data, and audio across existing Ethernet networks. Sending video
and audio over computer networks yields significant cost savings by
using an existing computer network to monitor a remote site
The NET350 saves installation costs (no separate cabling required),
allows toll-free operation (intranets), and saves management costs
(single, uniform network). With minimal setup, the NET350 trans-
mission system can be installed and running in minutes.
When using a NET350T and a NET350R, connect a camera to a
transmitter and an analog monitor to a receiver. Then connect the
transmitter and receiver to the network and configure IP addresses
for the equipment using a standard terminal program or any Internet
browser. If you need to control a camera (operate pan, tilt, and lens
functions, or do presets and patterns), an RS-232 data interface links
the keyboard controls to the network and then from the network to
the camera system.
Instead of (or in addition to) a receiver and monitor, an Internet
browser can be used at the receiving end to display video on a PC. On-
screen keyboards in the NET350 let you control the following devices
over the network: System 9700 Series or CM6700/CM6800 matrix
controller, Genex multiplexers, Spectra domes, and Esprit positioning
systems.
All recordings can be stored locally using a CompactFlash® card or
miniature disk drive (up to 1 GB capacity).
The NET350T, featuring CompactFlash and dual MPEG-4 video
streams, lets you use computer networks to interface your control
and monitoring stations with remote camera sites, whether they are
in the same building, across the country, or around the world.ELEC 095
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.