P-NUCLEO-IHM03 - Motor Control Nucleo Pack with NUCLEO-G431RB and X-NUCLEO-IHM16M1
Description
The P-NUCLEO-IHM03 STM32 motor-control pack is a kit composed of the X-NUCLEO-IHM16M1 board, the NUCLEO-G431RB board, a brushless Gimbal motor (GBM2804H-100T), and the DC power supply.
This platform provides a motor-control solution for three-phase, low-voltage and low-current DC brushless or PMSM motors. It is based on the STSPIN830 driver and on the STM32G431RB MCU.
The STSPIN830 is a compact and versatile FOC-ready driver for a three-phase motor. In a very small 4 x 4 mm QFN package, it integrates both the control logic and a fully protected low-RDSon triple-half-bridge power stage. It supports both single- and three-shunt architectures and embeds a PWM current controller based on user-settable values of reference voltage and OFF time. Thanks to a dedicated MODE input pin, the device offers the freedom to decide whether to drive it through 6 inputs (one for each power switch) or a more common 3 PWM direct-driving inputs.
The STM32G431RB is a 32-bit microcontroller based on a high-performance Arm®Cortex®-M4 32-bit RISC core, with floating point unit (FPU), operating at a frequency of up to 170MHz, embedding an advanced analog peripheral set.
The X-NUCLEO-IHM16M1 board is fully configurable and ready to support different closed-loop control, FOC or 6-steps, based on sensorless or sensor mode. It is compatible with three shunts or single shunt for current-sense measurement.
All features
- X-NUCLEO-IHM16M1:
- Three-phase driver board for BLDC/PMSM motors based on STSPIN830
- Nominal operating voltage range from 7Vdc to 45Vdc
- Output current up to 1.5Arms
- Over-current, short-circuit, and interlocking protections
- Thermal shutdown and under-voltage lockout
- BEMF sensing circuitry
- Support of 3-shunt or 1-shunt motor current sensing
- Hall-effect-based sensors or encoder input connector
- Potentiometer available for speed regulation
- Equipped with ST morpho connectors
- NUCLEO-G431RB:
- STM32G431RB 32-bit microcontroller based on the Arm®Cortex®-M4 core at 170MHz in LQFP64 package with 128Kbytes of Flash memory and 32Kbytes of SRAM
- Two types of extension resources:Arduino™ Uno V3 expansion connectorST morpho extension pin headers for full access to all STM32 I/Os
- On-board STLINK-V3E debugger/programmer with USB re-enumeration capability: mass storage, Virtual COM port, and debug port
- 1 user and 1 reset push-buttons
- Three-phase motor:
- Gimbal motor: GBM2804H-100T
- Maximum DC voltage: 14.8V
- Maximum rotational speed: 2180rpm
- Maximum torque: 0.981N·m
- Maximum DC current: 5A
- Number of pole pairs: 7
- DC power supply:
- Nominal output voltage: 12Vdc
- Maximum output current: 2A
- Input voltage range: from 100Vac to 240Vac
- Frequency range: from 50Hz to 60Hz
-

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.