NodeMCU ESP8266 Development Board 0.96 inch OLED Display with Protector Case

• NodeMCU ESP8266 WiFi Development Board with Built-In 0.96\" OLED Display and Protective Case

  An ESP8266 WiFi board with the OLED screen already mounted. You don’t have to wire a separate display. Plug it in over USB, program it from the Arduino IDE, and show sensor readings, network status, clocks, or project data right on the board. The case protects the board and screen on the bench or in a finished build.

  Features:

  • ESP8266 WiFi microcontroller with 4MB flash
  • Built-in 0.96\" 128x64 OLED display (SSD1306 driver, I2C)
  • [CH340 / CP2102] USB-to-serial chip for direct programming over USB
  • Protective case included
  • Works with Arduino IDE, MicroPython, NodeMCU Lua, and PlatformIO
  • Standard NodeMCU pinout with GPIO, I2C, SPI, UART, PWM, and ADC

  Good for:

  • IoT sensors and home automation
  • WiFi weather stations and clocks
  • Network monitors and status displays
  • Student, hobby, and maker projects

  Getting started:

  1. Install the USB driver for [CH340 / CP2102] if your computer doesn’t detect the board.
  2. In Arduino IDE, add the ESP8266 board package. Select “NodeMCU 1.0 (ESP-12E Module)”.
  3. Install the “ESP8266 and ESP32 OLED driver for SSD1306” or “Adafruit SSD1306” library to drive the screen.

  What’s included:

  • 1x NodeMCU ESP8266 board with 0.96\" OLED
  • 1x protective case [per board]
  • USB cable not included

  Shipping and support:

  • Ships fast from the USA
  • ALL tested
• Type: Development Board
• Chipset: ESP8266 (ESP-12E/F)
• Display: 0.96\" OLED, 128x64, SSD1306, I2C
• Connectivity: WiFi 802.11 b/g/n, USB
• USB Interface: [Micro-USB / USB-C]
• USB-Serial Chip: [CH340 / CP2102]
• Compatible With: Arduino IDE, MicroPython, NodeMCU Lua, PlatformIO
• Operating Voltage: 3.3V logic, 5V USB power
• Included: Board with OLED, protective case

KB TinyBoards