New Automatic Controller For Generator Control Unit GCU-10 GCU10

Description:
GCU-10 Generator Control Unit is an universal economical programmable genset controller. Equipped with high illuminating LED with universal graphical
interface helps to notify the operator the generator status. Optional relay moduleGCU-11R (12V/24V) helps to simplify the wiring and connection process
Features:
Microprocessor Based Design
Universal LED Graphic Interface, Displays Generator Status and Failures
Modular Design, Quick Installation
Programmable Engine & Generator Controls Adapts Easily To Any Type Generator Set.
Waterproof Front Panel With UV Protection
Provide IDLE control For Elec. Governors
Five Adjustable Time Delay Potentiometers
Five DIP Switches For Specification SettingSpecification:
DC Supply:9.0 to 36 VDC
Alternator Input Range:Voltage 5~300 VDC Frequency 50~60 Hz
Fuel Solenoid Signal Output:5 Amp @ 12/24 VDC
Start Signal Output:5 Amp @ 12/24 VDC
Warm up Signal Output:5 Amp @ 12/24 VDC
Accessory \" ON \" Output:5 Amp @ 12/24 VDC
Idle Control Conductor Capacity:5 Amp @ 12/24 VDC
Power Consumption:Under 3 VA on Auto
Adjustable Timers:
Engine Pre-Heat : 2~30 sec.
Starter Cranking Time : 1~15 sec.
Energize to STOP : 1~15 sec.
Engine Idle (Governor) : 0~300 sec.
Engine Cool-down : 0~300 sec.
Environment:
Operation Temperature : -20~70 °C
Relative Humidity : Maximum 90%
Protection & Alarm Status Indicators:
Start Failure
High Water Temperature
Low Oil Pressure
Overspeed
Underspeed
Emergency Stop
Extra Prog. Input
Low Battery Voltage
Panel Installation Cut-Out:66.0 x 66.0 ±0.5 mm
Dimensions:72.0 (L) x 72.0 (W) x 50.0 (H) mm
Weight:166 g ±2%

On Feb 22, 2024 at 04:45:02 PST, seller added the following information: