- COMPATIBLE WITH FCC ID: HYQ12BBT Replacement Key Fob Comes with installed Batteries
- REPLACEMENT: This Key Fob Replacement Is Compatible with Lexus 2004-2006 RX330 /2007-2009 RX350 / 2006-2008 RX400h/2010RX450h
- PROGRAMMING:Does not come with programming instructions. The item pictured is the exact representation of what you will be receiving. SEE A LOCAL AUTOMOTIVE LOCKSMITH FOR PROGRAMMING with DIAGNOSTIC EQUIPMENT - TAKES 5 MINUTES - NO DEALERS
- Frequency: 315 Mhz
- Battery: CR2016 installed
- for Keyway: TOY48 LXP90
- for ILCO C/R: AX00011960 (RHK-LEXUS-3B2)
- Buttons: Lock, Unlock, Power Door, Panic
ATTENTION: This remote key requires a TWO PART programming process:
PART #1:
Programming Instructions for Remote Control (Lock & Unlock your vehicle doors etc.):
1. Driver\'s door open, all other doors closed, key removed from ignition switch.
Within 5 seconds:
Insert and remove the key from the ignition switch twice.
2. Within 40 seconds:
Close and open driver\'s door twice.
Insert and remove the key from the ignition switch.
3. Within 40 seconds:
Close and open driver\'s door twice.
Insert the key into the ignition switch and close the driver\'s door.
4. Switch ignition ON and OFF:
A. Once to program a key remote transmitter code whilst retaining the original codes.
B. Twice to program a key remote transmitter code whilst erasing the original codes.
C. Three times to check how many key remote transmitters are currently registered.
D. Five times to erase all registered codes.
5. Remove key from ignition switch. System should now lock and unlock vehicle
once, twice or five times depending which mode has been selected. One to four
times, slowly, to indicate number of key remote transmitters registered.
6. Within 40 seconds:
Press and hold LOCK and UNLOCK buttons simultaneously for 1.5 seconds.
Within 3 seconds: Press any key remote transmitter button.
System should now lock and unlock vehicle once to confirm registration or twice
to indicate registration has failed.
7. Within 40 seconds:
To program additional remotes repeat step 60 now on each additional
remote you want programmed.
8. To exit programming mode open driver\'s door or insert key into ignition.
9. Step out of car with remote(s) in hand and test remote(s).
PART #2:
Programming Instructions for Transponder Chip:
the manufacturer’s programming instructions For your vehicle make model and year
specify diagnostic programming required
This keyless entry\'s TRANSPONDER CHIP requires programming by your local or locksmith.
You will need to visit your local dealer or locksmith to have your
remote programmed to your car using diagnostic equipment
LOCKSMITH = Least expensive… no dealers
for your installed remote keyless system.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.