Motion Raceworks V2 LS Flex Line Coolant Crossover Steam Kit for Low Pro Plastic

Motion Raceworks all new V2 Flex Line steam kit is the solution to your LS1 coolant crossover/steam kit issues facing stock and aftermarket low profile plastic intake manifolds. Many aftermarket intakesand some stock intakes do not have clearance under the intake to run a proper steam kit coolant crossover setup. Motion has proven this kit for the Fast 92, LS6, LS1, LS2, LS3. We will NOT return this kit if you order for another intake and it does not fit. There are too many variations. This kit is 100% made in the USA and designed by Motion Raceworks.Parts are machined from6061 aircraft aluminum. Also utilizes top quality Fragola lines. This kit allows you to have a high flow 4 CORNER coolant crossover with a common manifold. This kit will work with stock LS1, LS2, LS3, LS6, LS7 intakes and other variations of LS engines. Do not risk premature engine failure due to blocking off rear coolant crossover/steam ports. These kits are recommended by nearly all aftermarket engine builders!(Fast 92 intake pictured).Note: This kit comes with a -4AN malefitting to return coolant back to your RADIATOR. No line is included as routing and length varies depending on application. We always suggest running the coolant crossover return line to a fitting just below the radiator cap. This allows the pressure and air to be sent to an area just below the radiator cap, allowing the radiator cap to release pressure as intended thereby removing the steam/pressure from the system. Plumbing to the waterpump risks reintroducing steam/air pressure back into the system.This kit will work with stock LS intakes (not a truck intake)and rails, as well as aftermarket rails. This kit also works with Fast 92 Intakes, as well as a variety ofothers. DOES NOT FIT THE FAST 102 intake.

• 4 Corner manifolds w/ AN fittings
• 1 5 Port Common Manifold
• 1 Mounting Bracket
• 4 Black coated Fragola lines
• All necessary hardware***Note, no radiator return line included