|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Magnetic Connector for CNC Router Touch Plate Edge Finder corner zero alligator
$5.52

Magnetic Connector replaces alligator clip. Safer - Faster - Easier - Reliable Speedy Magnetic Connector for CNC Router Touch Off Plate Edge Finder corner zero. Magnetic electrical probe contact connector clip. Note: Does not include Edge-Finder, wire, spindle motor, or router bit. Attaches to any size Spindle motor nut. Easy to Install on all CNC models where a connection to a spindle probe is required for proper probe operation. When installed as shown, the wire loop design creates a strain relief effect that protects the connection for longer wire wear life. This speedy-magnetic connector is the ideal for creating a safe and secure electrical connection to the spindle of your CNC probe. The speedy-magnetic probe connector simplifies operation and adds safety as well. Merely touch the speedy-magnetic connector to the spindle nut and there is an instant electrical connection to the probe. The operation is fast, easy, and secure. It may be safer to use than an alligator clip. Magnetic clip will pop off and away from the spindle if spindle is accidentally started, reducing the possibility of injury to operator and damage to CNC is completely compatible with the Vancura Innovations Zero Corner Edge Finder, as well as most probes and touch-off plates on all CNC machines that support touch YOU GET: One Speedy-Magnetic connector clip consisting of a 1) 12mm Nickel plated Neodymium N50 rare-earth magnet, 2) Attaching screw, and 3) Aluminum cable strain relief. 4) Basic assembly Innovations has an experienced electrical/electronics engineer to answer your questions intelligently. Our engineer has owned and operated a CNC machine for over ten years. He knows CNC. ================ See the compatible and incredibly useful Edge finder probe. Search for: Zero Corner Edge Finder Please give positive response on your purchases. Contact us first if you have any problem.CNC systems are dangerous. We cannot be held liable for anyone using unsafe operating practices while using this device. Please be careful!=====Side note: If your system does not have a touch plate input but has a controller board similar to the one pictured above and has software that supports touch plates (such as Mach 3), it is most likely possible to add a touch plate. Contact me for details.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|