Lone Buck Guitars Luthier's Compact Reversible Trim Router Table With Fence

This is the Lone Buck Guitars Compact Reversible Trim Router Station. I created this out of the need for something smaller than my large stationary router for Lutherie work such as flattening fingerboard blanks, trimming edges of sides and fingerboards, and routing the edges of fingerboards for bound edging. As a small builder, I have several trim routers that I use for different tasks. I wanted a small station that I could use specifically for these smaller tasks that didn\'t take up a lot of floor space. This allows me to bolt the station to my work bench, do my work and then put it away when done.I make these from 1/2\" HDPE plastic which makes them tough and has a slightly textured surface making them \'slick\' for the wood to slide across. The fence is removable and has adjustment knobs on both sides allowing for a lot of flexibility. I also include two 1\" high rails that can be bolted onto the board allowing it to be flipped over and used as a flattening tool.I ship them without router mounting screw holes drilled out allowing you to drill out to match the router you already own. The pictures show a Ridgid router mounted for demonstration purposes only as I use that router on my station. Yours will come undrilled.

Included are the following:

• Router Station Top 8 1/2\" x 11 1/2\" x 1/2\" thick
• Fence with two screws and brass thumb nuts
• Centering hole for use when drilling out your router holes. Can be used as a close insert afterwords.
• 2 bottom rails for flattening purposes
• 1 handle
• 1 clamp for dust collection tube with screws
• 1 - 1\" dust collection tube with angled end
• 1 - 1\" dust collection tube with down facing intake
• 1 - 1\" coupling for dust collection tube
• Screws for mounting the rails.

Great for:

• As a router table
• As a traditional handheld router
• Normal table routing
• Pattern routing
• Edge trimming

Router and dust collection system is not included.