Kel-Tec P17 Dry Fire Block (3 Pack)

The Item you will receive is black. The cover photo is tan because it was too hard to take good pictures of the black part.
We all know it is not good to dry fire .22LR. And it can be a pain to take the firing pin out or even worse use a bunch of snap caps that fall all over the place. This little block lets you dry fire your P17 without any snap caps or modifications! Just install and dry fire away!
All this is doing is blocking the hammer from striking the firing pin. It's 3D printed in PLA+ for extra durability and each block will likely give you about 5k-10k dry fires. Which is why I will be including 3 blocks in each pack. So these will last a long time.
This is not meant to be used as a safety device so make sure the firearm is still unloaded while dry firing.