This item ispre-owned – it will work like new once programmed to your vehicle
One (1)
Aftermarket remote keyless entry fob alarm
Transmitter control clicker keyfob controller replacement
Functions at 100%Tested & Guaranteed
DELTA
FCC ID: J5523518TI
DELTA
3 buttons
Programming Instructions:
Programming Instructions:
1. Locate valet switch.
2. Insert key into ignition and turn to “on” position- (do not start the vehicle)- and then back “off”.
3. Repeat again- “ON”, “OFF”, “ON”- ending in the “ON” position. –The vehicle lights should flash at this point, indicating the vehicle has successfully entered programming mode.
4. Hold down Valet switch for 5 seconds. – Vehicle lights will flash again.
5. Within 15 seconds, hold down “lock” button on first remote- vehicle will confirm with a chirp or lights flashing when remote has been accepted.
6. Repeat step 5 with any remaining remotes.
7. To exit programming turn the key to “off” position.
METHOD #1:
You will need two things
1. The remote control
2. Valet Switch (aka: programming switch) (you will see asingle Push button switch typically red or blue button and in the kick panelarea under front drivers dash)
To program you have about15 seconds¦
Can program up to 4transmitters (program sequentially at the same time)
1. Get in vehicle
2. Key in Ignition
3. TURN ignition ON OFF ON OFF ON (leave on)
4. Lights in vehicle will flash leave key on
5. Grab valet switch
6. Push (hold down) button for 5 seconds
7. You will either hear a chirp or see a light flash let go
8. Grab transmitter (first to program) & hold down lockbutton until you either hear a chirp or see a light flash – let go
9. Grab 2nd remote & hold down lock button until youeither hear a chirp or see a light flash – let go
10. Grab 3rd remote – & hold downlock button until you either hear a chirp or see a light flash – let go
11. Grab 4th remote & hold down lockbutton until you either hear a chirp or see a light flash let go
12. Typically, about a 15 second windowto do all of this in
13. To exit program, turn key off
METHOD #2:
Programming Instructions:
This system uses CodeLearning to learn up to 3 different transmitter codes.
TO PROGRAM TRANSMITTERSTO ALARM:
1) Turn ignition switchON then OFF 3 times quickly (on/off, on/off, on/off) until siren chirps once.
2) Leave ignition ON.
3) Push & Hold the Valetswitch. The siren chirps 3 times.
The system is now inprogramming mode.
4) Press BUTTON #1 on thetransmitter- siren chirps once to confirm programming. Press BUTTON #1 onanother transmitter within 5 seconds to program a second remote control.
NOTE #1
If only one transmitteris being programmed, continue holding BUTTON #1 until Siren chirps a secondtime. This means the system has exited program mode. Hold the transmitterbutton until the siren chirps the 2nd time to prevent unauthorized code and noisefrom entering system.
NOTE #2
Program Mode is exitedautomatically after 5 seconds of last code transmission or once 3 new codeshave been programmed. System will disarm after programming. Disarm using anyvalid transmitter.
5) Turn Ignition to OFF.
NOTE: When programmingALL remotes must be relearned!
100%Guarantee Remote Shipping / Return Policy
Yes. Itwill have a working battery installed.
Theabove information can change which remote you need
for your installed remote keyless system
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.