|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Hosyond 4Pack 4 Channel DC 5V Relay Module with Optocoupler Relay Board for A...
$25.47

Hosyond 4Pack 4 Channel DC 5V Relay Module with Optocoupler Relay Board for Arduino Raspberry Pi MEGA2560 Product Details Size: 4 Channel Brand: Hosyond UPC: 732214748170 EAN: 0732214748170 MPN: Does not apply - Connector Type: Dupont
- Contact Type: Normally Closed, Normally Open
- Current Rating: 10 A
- Mounting Type: Plug In Mount
- Brand: Hosyond
- Connector Type: Dupont
- Contact Type: Normally Closed, Normally Open
- Current Rating: 10 A
- Mounting Type: Plug In Mount
- Operation Mode: Automatic
- Coil Voltage: 5 volts
- Maximum Switching Current: 10 A
- Minimum Switching Voltage: 5 volts_of_direct_current
- Brand Name: Hosyond
- UPC: 732214748170
- Warranty Description: NO
- Included Components: NO
- Manufacturer: Hosyond
- The power supply voltage of the relay module is DC5V. The maximum output load is AC250V 10A and DC30V 10A.
- The relay has a standard interface and can be directly connected to the microcontroller, which is convenient for wiring. Package contains 10pin male to female DuPont wires.
- High Level or Low Level Trigger. Pull in at low level and release at high level. The status indicator is on when it is pull in, and it is release when it is released.
- The 4 channel relay interface board can directly control Arduino, AVR, PIC, ARM, PLC and other microcomputers, and can also control various high-current electrical appliances and other equipment.
- Widely used in all MCU control, industrial fields, PLC control, smart home control.
Module parameters: ▪Size: 71.5mm(L)52.7mm(W)18.5(H)mm ▪Single weight: 56g▪PCB color: blue ▪There are 4 fixing screw holes around the board, the holediameter is 3.1mm, which is convenient for installation and fixing ▪Highquality relays. A common end, a normally open end, and a normally closed end.▪Optocoupler isolation, good anti-interference. ▪High Level or Low LevelTrigger. The status indicator is on when it is engaged, and it is off when itis released. ▪VCC is the system power supply, JD_VCC is the relay powersupply. Just plug in the jumper cap. ▪Power supply voltage: 5VDC ▪Current:more than 100mA ▪Load: 250V 10A AC or 30V 10A DC Wiring instructions: VCC:positive pole of system power supply GND: Negative pole of system power supplyIN1--IN2: relay control port (Do not reverse the connection to avoid burningout) Packing List: 4 x 4 channel relay module 1 x 10pin F-M Dupont wire

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|