Hose Timer Mounting Bracket – Compatible with Orbit B Hyve XD 4
- SUPPORT YOUR WATERING — Stop leaving your hose timer and connected hoses hanging unsupported from their connections. This mounting bracket holds your hose timer at your outdoor watering setup, giving it a supported position while the hoses are attached. When you connect the lines that water your garden beds or yard, your timer has a mounting point instead of hanging from the water connection alone.
- BOTTOM FIRST FIT — Pop your hose timer\'s four lower ports into the bracket, then flex the top up over the threaded inlet. Installation follows those connection points, seating the bottom before bringing the top into place. At your garden tap, that gives you a clear fitting sequence and a bracket that holds your timer at its lower ports and upper inlet, right where it joins your watering setup.
- FENCE MOUNTING OPTIONS — Attach the bracket to a welded wire fence with cable ties, or plan your attachment around the retained screw holes. The top and back mounting holes are sized for M4 hardware, giving you a size to check when preparing your watering station. You get the plastic part only. Hardware required (not included): cable ties (mounting to wire fence).
- SUPPORT FROM BELOW — The back and bottom of the bracket carry the weight of your hose timer and connected hoses, while the top retains the inlet. The upper plate holds that connection in position rather than carrying the load beneath it. When several hoses meet at your garden tap, the bracket puts the weight-bearing support behind and below your timer, where the timer and hoses need it.
- ORDER AT THE TAP — Give your hose timer a place in your garden layout instead of letting the connections dictate where it hangs. A supported watering station keeps the timer positioned where your hoses meet, whether you are tending garden beds or managing watering around the yard. Plan your setup along a fence, wall or post so checking your timer is part of visiting the watering point, not sorting through hoses.
Your hose timer should not hang unsupported from its connections. Once the hoses are attached, give your watering setup a mounting point that supports the timer where you use it.
The SplashNColor hose timer mounting bracket holds your hose timer at your outdoor watering station. It supports the timer at its four lower ports and upper inlet. The back and bottom carry the weight of the timer and connected hoses, while the top retains the inlet rather than carrying that load. Your timer stays positioned as part of the watering setup instead of hanging from the water connection alone.
To fit your hose timer, pop the four lower ports into the bracket, then flex the top up over the threaded inlet. Start at the bottom and work upward, seating the ports before bringing the top over the inlet. The bracket uses those lower and upper connection points to hold your timer in place.
A welded wire fence gives you an attachment option using cable ties. The bracket also retains screw holes, with the top and back mounting holes sized for M4 hardware. Check your attachment plan against the bracket layout and the surface where you intend to mount it before assembling your watering station.
For gardeners tending beds and homeowners managing watering around the yard, this bracket gives the timer a place in the outdoor layout. Build your watering station along a fence, wall or post where the hoses connect. When you head outside to check your timer before the next watering cycle, it stays supported at the point where you use it. Keep the timer and hose connections arranged together, with support beneath and behind the timer rather than relying on its connections to carry everything.
The box holds the plastic part only. Hardware required (not included): • Cable ties (mounting to wire fence)
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.