Honeycomb Table Connecting Brackets Compatible with Xtool D1 pro

• SQUARE YOUR BED — When your honeycomb bed sits out of line with your laser engraver's frame, arranging the cutting surface becomes another setup task. These connecting brackets square the bed within your extended working area, so you line up the panel with the surrounding platform before laying out your next cutting job in your home studio or personal workshop.
• SUPPORT THE CUTTING SURFACE — Give your honeycomb bed support within your laser engraver's extended working area. The bracket profile matches the placement areas on the extension assembly, bringing the bed into the surrounding platform layout; when you arrange your workshop cutting station, those matching positions give you a physical starting point for placing the panel.
• FOLLOW THE PANEL EDGES — Check your honeycomb bed against the 950 x 460 mm panel size used for this setup before choosing your brackets. Their outer profile follows the panel edges, placing the support alongside the cutting surface rather than leaving you to judge its position in open space; use those edges as your guide while arranging the bed on your extended machine.
• PLACE BY HAND — Position the brackets by hand alongside your honeycomb panel in the corresponding areas of your laser engraver's extension assembly, bringing the support into place as you arrange the cutting surface. You get the plastic part only; any screws, adhesive or anything else your setup calls for is not included. Line up the bed before laying out a project in your workshop.
• FINE TUNE YOUR LAYOUT — Make small placement changes while arranging your honeycomb bed instead of committing to its first position. The bracket outline leaves room for slight shifting, so you adjust the panel's position as you square it on the extended platform; that movement gives you room to refine the arrangement at your cutting station before starting your next project. WHAT'S IN THE BOX — Only the item named in the title. No hardware is included (see the description).

Your honeycomb bed needs to sit square with your laser engraver's extended working area. When the panel and surrounding platform are out of line, arranging your cutting surface becomes another task before the project begins.

SplashNColor honeycomb table connecting brackets support and square your honeycomb bed within that extended setup. Their outline follows the panel edges and corresponds to the placement areas on the matched extension assembly, bringing the cutting bed into alignment with the surrounding platform. The brackets work alongside the bed, giving you a physical guide for positioning it as you arrange your cutting station.

Check your honeycomb bed against the 950 x 460 mm panel size used for this configuration. That measurement describes the bed, not the brackets, and belongs alongside the machine and extension-kit compatibility when choosing your accessory. These brackets are for an Xtool D1 pro setup with an extension kit.

Place the brackets by hand in the corresponding positions alongside the honeycomb panel edges. As you arrange the bed, the outline leaves room for slight position changes, so you make small adjustments while squaring the panel with the platform. Support, edge alignment and adjustment work together during setup, before you lay out your next cutting job.

For laser engraver owners working in a home studio or personal workshop, these brackets put attention where a cutting setup starts: the bed's position within the machine.

HARDWARE NOT INCLUDED: Only the item named in the title is in the box. Every setup is different: depending on yours, mounting it or attaching it to an existing part may use hardware you already have, such as the original screws, or you may need to buy your own screws, bolts, tape or adhesive to suit your situation. No hardware of any kind is included with this listing.

Hardware details: the box holds the plastic part only. If your setup needs screws, adhesive or other fasteners, they are not included.