|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
High Load Priming T-Pull / Ring-Pull (PETG) for Adventure Force Sentry X2
$8.01

NOTE: New pictures to come shortly. These current pictures are for the other attachment style of T-Pull I offer for the Sentry X2. Attachment style is different but pull styles are the same.These pulls for the Adventure Force Sentry X2 allow for a more convenient prime of the blaster. These pulls also support higher spring loads by being installed in place of the prime lock. Available in two T-shapes or a Ring style.Includes: 1x Adventure Force Sentry X2 High Load T-Pull or Ring-Pull.Installation: Remove the top priming slide from the blaster by unscrewing all 5 screws (4 on the left side, 1 on the right side). Remove the prime lock from inside the slide (orange piece with a spring attached to it). Install the priming pull with the two raised ridges facing up. Screw it all back together and you\'re set.Attribution: Designed by Transmogrification Labs.Notes about material: This product is printed in PETG material which offers superior thermal resistance and increased durability compared to PLA products. PETG has a higher glass transition temperature of 80°C whereas PLA is 60-65°C. For PLA, this is within range of the temperatures that often occur inside a vehicle during summertime so items made from PLA may end up warping in those situations. The same issue can possibly occur from exposure to direct sunlight if the temperature is high enough. PETG has a much higher glass transition temperature however so you are very unlikely to ever experience issues with it warping in addition to it just being stronger in general. PETG products do come at a higher cost than the same product in PLA because PETG takes longer to print and also requires more time to clean up after printing but the result is a very high-quality product.Disclaimer: All of my products are printed and tested with the utmost attention to detail. Despite this, I am NOT responsible for any damage incurred to you or your blasters through the use of any of these parts alone or a combination with others. It is up to you to keep yourself and your blasters in functioning condition. Some prints may have visual imperfections as is common to all 3D printing (especially for PETG). These slight imperfections will not interfere with mechanical function or integrity/strength. Powered by ExportYourStore.com

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|