Free Userbar - Userbars - User Bar - User Bars
 
Advanced search
Registered users

Username:

Password:

Log me on automatically next visit?

¬ Forgot password
¬ Registration

» Upload Userbar
» Animate Userbar
» Userbars Tutorial
» Userbar Tournaments
» Forum
» Chat Room
» FAQ
» Links

• PC Cheat Codes

>> If you dont know how to design a userbar, then write here a Userbar that you want. >> If you know how to design them help these people and design what they request.




USERBARS.org | Free Forum Userbars

On eBay now
eBay

HiLetgo 4pcs L298N Motor Driver Controller Board Module Stepper 4pcs, Red

HiLetgo 4pcs L298N Motor Driver Controller Board Module Stepper 4pcs, Red
$17.88

Buy Now

HiLetgo 4pcs L298N Motor Driver Controller Board Module Stepper 4pcs, Red
Product Details
  • Publisher: HiLetgo
  • Publication date: 0
  • Dimensions: 6 x 5.5 x 3 cm
  • L298N as main driver chip makes strong driving ability/small heating/strong anti-interference/low calorific value
  • Dual-channel H-bridge driver working mode creates higher working efficiency
  • To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage
  • Large capacity filter capacitance, afterflow protection diode, more stable and reliable

Specification:Chip: ST L298N dual H-bridge driver chipLogic voltage: 5VLogic current 0mA-36mAStorage Temperature: -20 ¡æ to +135 ¡æOperating mode: H-bridge driver (dual)Drive voltage: 5V-35VDrive current: 2A (MAX single bridge)Maximum power: 25WDriver Board Size:55mm*60mm*30mmDriver Board Weight:33gDimensions: 43x43x27mmNote:.General Application: When your driver is 7V-12V, you can enable the on-board 5V logic supply. When using the on-board 5V power supply, the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use..Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply.Package Included:4* L298N Motor Driver controller Board ModuleThere are two ways to turn the system back on:1. flip the power switch on the back of the computer and wait for the power supply cap to discharge as the relay will reset without power.2.after popping the hood and examining for faults, press the button on the relay.There is a red LED on this for power and a green LED to indicate the relay is activated, so you can be pretty sure what state this is in .Any time you are trying to hot wire an ATX power supply and you need a toggle function besides the switch in the back, just needs power from pin 9, the relay connected to pin 16 and then of course connections back to ground pin(s).

Buy Now

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Related Userbars
       

More items on eBay

As an eBay Partner, userbars.org may earn a commission from qualifying purchases.



All userbars are property of respective authors.
Copyright © 2002 4homepages.de | Template © 2005 Bali Web Design