Hanna Controller HI 710 221

The HI 710 series is a real time microprocessor-
based EC or TDS controller. It provides accurate
measurements, flexible ON/OFF or proportional control ca-
pabilities, analog input and output, RS485 port, dual setpoint
and alarm signal.
The system is composed of a case inside which the signal
conversion circuitry, the microprocessor circuitry and the output
power drivers are contained.
MAIN FEATURES OF DIFFERENT MODELS
• Display: large LCD with 4 ½ 17 mm digits and 3 ½ 10 mm
digits.
• LEDs: four LEDs are provided for signaling the energizing
of relay 1 and 2 (yellow LEDs) and alarm relays (a green
and a red LED).
• Relays: 1 or 2 output relays for low conductivity or high
conductivity dosage (COM, NO and NC contacts) and 1
output relay for alarm condition (COM, NO and NC con-
tacts).
• RS485 isolated communication link (HI 700222 and HI
710222 only).
• Calibration and Setup procedures allowed only through
an unlock password.
• Calibration: 2 points with Hanna EC and TDS calibration
solutions.• Four different EC working ranges (0 to 199.9μS; 0 to
1999μS; 0 to 19.99mS; 0 to 199.9mS).
• Four different TDS working ranges (0 to 100.0ppm; 0 to
1000ppm; 0 to 10.00ppm; 0 to 100.0ppm) for HI 710
models.
• Possibility to switch to TDS measurements with conversion
factor from 0.00 to 1.00 (HI 710 models only).
• Temperature compensation of the HANNA standard solu-
tions.
• Temperature compensation of the EC and TDS reading with
temperature coefficient ß selectable from 0 to 10%/°C.
• Manual temperature setting when the temperature probe is
not inserted or temperature exceeds the upper range.
• Last calibration data internally recorded (non-volatile EE-
PROM memory): calibration date and time, cell constant,
calibration solution values.
• Input:4-ring EC/TDS probe with cell constant 2.0 ± 10%,
or 4-20mA analog input from a transmitter.
• Output (HI 700221 and HI 710221 only):
- isolated 0-1 mA, 10 KΩ maximum load (optional);
- isolated 0-20 mA, 750 Ω maximum load (optional);
- isolated 4-20 mA, 750 Ω maximum load (optional);
- isolated 0-5 VDC, 1 KΩ minimum load (optional);
- isolated 1-5 VDC, 1 KΩ minimum load (optional);
- isolated 0-10 VDC, 1 KΩ minimum load (optional).
• Real time clock.