TheHPI Racing part #88008 Cone Washeris a factory-spec genuine replacement hardware component designed with a 3x9x2mm dimension and a gunmetal finish. It primarily serves to spread clamping loads and keep fasteners seated securely during high-vibration RC operations.Scale and DimensionsThe dimensions specified in the name dictate its hardware sizing scale rather than a specific vehicle chassis type, though it is physically used on specific vehicles.
- Inner Diameter (ID): 3mm (designed for M3 metric screws/hardware)
- Outer Diameter (OD): 9mm
- Width/Thickness: 2mm
- Target Vehicle Scale: Primarily used in 1:10 scale radio-controlled vehicles.
CompatibilityThis part is a genuine factory replacement explicitly designated for the following HPI platforms:
- HPI E10 (Electric Touring platform)
- HPI E10 Ford Mustang
- HPI E10 Drift
Because it is an M3 counter-sunk / cone washer, it can technically be used customly in any RC application requiring an aluminum cone washer to spread the load of a 3mm flathead screw, but it is explicitly listed as a standard maintenance part for the front/rear assemblies of the E10 platform. LOC G
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.