Golf Club Length Measuring Ruler Attachment - For Empire

Measure club length the way the USGA does. This attachment slides onto an Empire 4004 48\" aluminum ruler and sets the club at exactly 60°, the official plane for measuring drivers, fairway woods, hybrids, irons and wedges. Ruler not included with purchase.

Accurate from zero. Both 60° walls meet right at the ruler\'s zero mark. A shaft guide keeps the club centered over the ruler, and the open top lets everything from wedges to drivers drop right in.

Built to hang. The ruler\'s hang hole stays open with the attachment installed, and ledges under the ruler keep it from sliding out. The whole setup hangs on a hook or nail instead of taking up bench space.

SpecificationsMeasuring Plane60° [USGA method]Club TypesDrivers, fairway woods, hybrids, irons and wedgesCompatible RulerEmpire 4004, 48\" aluminum - Not IncludedHandRH and LHMaterialPETGRulerNot includedOriginDesigned and 3D printed by 704 Clubworks, Made in USA

Key Features

• Holds every club at exactly 60° measuring plane.
• Shaft guide centers the club for a straight, repeatable reading.
• One attachment covers right- and left-handed clubs.
• Slides on with no tools and locks in by friction.
• Hangs on the wall with the ruler attached.
• Strong PETG won\'t warp in a hot garage or car.

Not compatible: Putters are measured along the shaft axis instead of a 60° plane and aren\'t covered by this listing. Rulers other than the Empire 4004 haven\'t been confirmed.