I bought this and ended up not needing it. Includes the unit and the power cable. Here is the description from 1uprestorationsNote that the wifi module is installed.---
The GBS Control is an open source upscaler that was created to be a low cost, high quality addition to the retro gaming world. Each unit comes fully assembled with a case.
Our GBS control comes with a euro scart input, and has a switch for toggling a 100ohm resistor to ground on the sync line. This can help with RGB sync on some consoles
Taken from the GBS Control wiki -
Gbscontrol is an alternative firmware for Tvia Trueview5725 based upscalers / video converter boards.
Its growing list of features includes:
- very low lag
- sharp and defined upscaling, comparing well to other -expensive- units
- no synchronization loss switching 240p/480i (output runs independent from input, sync to display never drops)
- on demand motion adaptive deinterlacer that engages automatically and only when needed
- works with almost anything: 8 bit consoles, 16/32 bit consoles, 2000s consoles, home computers, etc
- little compromise, even though the hardware is very affordable
- lots of useful features and image enhancements
- optional control interface via web browser, utilizing the ESP8266 WiFi capabilities
- good color reproduction with auto gain and auto offset for the tripple 8 bit @ 160MHz ADC
- optional bypass capability to, for example, transcode Component to RGB/HV in high quality
Supported standards are NTSC / PAL, the EDTV and HD formats, as well as VGA from 192p to 1600x1200 (earliest DOS, home computers, PC). Sources can be connected via RGB/HV (VGA), RGBS (game consoles, SCART) or Component Video (YUV). Various variations are supported, such as the PlayStation 2\'s VGA modes that run over Component cables
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.