Flight Simulator Mount Compatible with Winwing PAP3N
- BRING CONTROLS TOGETHER — Separate panel and throttle placements leave your flight simulator controls spread across your desk. This mount attaches your panel to your throttle assembly, bringing both into one desktop or home-cockpit setup so you build your flying station around controls that belong together instead of finding a separate spot for the panel.
- 15-DEGREE PANEL TILT — Put your flight simulator controls at a defined 15° angle as you assemble your cockpit. The mount sets the panel at that tilt on your throttle assembly, giving you an angled control layout for flight sessions at home; use that known angle when planning how your panel sits in relation to your seat, screen, and the rest of your simulator equipment.
- LEFT AND RIGHT — Know which bracket goes where before you start arranging your flight simulator controls. The mount uses distinct left- and right-hand brackets that sit on the top surface of your throttle assembly; match each bracket to its corresponding side as you position the mount, so the installation follows the layout of your throttle rather than a separate desk-mounted arrangement.
- REUSE EXISTING SCREWS — Fasten the mount at your throttle\'s existing top mounting points: remove the two outermost screws, position the brackets, and reinstall those original screws.
- NO WASHERS NEEDED — Complete the panel mounting through the rear screw holes, without adding washers to that connection. The rear-hole fastening step joins your flight simulator controls to the mount after the brackets are positioned on your throttle, giving you a clear assembly sequence when you put together a desktop flying station or arrange the controls in your home cockpit. WHAT\'S IN THE BOX — Only the item named in the title. No hardware is included (see the description).
When your panel and throttle sit separately, your flight simulator controls end up spread across the desk. Building a home cockpit means deciding how those controls will sit together, not just finding another spot for the panel.
The SplashNColor flight simulator mount is a plastic part that attaches your panel to the top of your throttle assembly. It brings those controls together in a desktop or home-cockpit layout and positions the panel at a 15° tilt. That defined angle gives you a starting point for planning the panel\'s position in relation to your screen and seat.
Installation follows the mounting points on your throttle. Remove the two outermost screws from its top surface, match the left- and right-hand brackets to their corresponding sides, and place them on top. Reinstall the original screws to fasten the brackets. For the panel connection, use the four silver-gray M5 screws, about 27 mm long, from your control panel\'s package through the rear screw holes. No washers are needed at that connection.
For flight-simulation enthusiasts assembling a desk station or building a cockpit at home, this mount makes the panel part of the throttle arrangement rather than a separate piece of equipment sitting alongside it. Your throttle\'s existing top mounting locations anchor the brackets, while the rear screw connection attaches the panel at its defined tilt. Whether you are arranging a dedicated flying desk or fitting out a home cockpit, you get a direct way to join your flight simulator controls into one setup for your next flight session.
HARDWARE NOT INCLUDED: Only the item named in the title is in the box. Every setup is different: depending on yours, mounting it or attaching it to an existing part may use hardware you already have, such as the original screws, or you may need to buy your own screws, bolts, tape or adhesive to suit your situation. No hardware of any kind is included with this listing.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.