Dustbin Inlet Flap – Compatible with Roborock Q7 M5 / Q7 and M5
- MISSING FLAP FIX — If the little door disappeared when you emptied your vacuum, put a closure back at the dustbin inlet instead of leaving that opening uncovered. This replacement takes the place of a missing or damaged flap, giving collected dust a barrier at the entry point after cleaning so the debris your vacuum picked up has less opportunity to work its way back out.
- OPEN WHILE CLEANING — As your vacuum moves through your rooms, the hinged baffle rises under suction and opens fully so swept dust and debris enter the collection bin. Airflow moves the flap during the cleaning cycle, keeping the inlet open while your vacuum collects mess from your floors; you do not have to open the flap by hand each time you start a cleaning session.
- SNAP IN BY HAND — When you put the bin back together after emptying, press the locating pins into your vacuum\'s existing inner-shell slots for a tool-free fit at the inlet, using the mounting points already there without extra clips or complicated modifications. You get the plastic part only; any screws, adhesive or anything else your setup calls for is not included.
- LESS MESS EN ROUTE — Carry your vacuum\'s dustbin from the floor to the trash with a flap covering the inlet, rather than an open path for collected debris to escape. The closed baffle limits dust falling back through that entry as you transfer the bin for emptying, keeping your attention on getting the contents into the trash instead of watching a second opening along the way.
- CLOSED BETWEEN CLEANINGS — Once your vacuum stops pulling air, the hinged flap returns to its closed position without a separate step from you. While your vacuum is parked on its charging dock, that closure keeps collected dust behind a barrier instead of leaving the entry open, limiting backflow through the inlet as your vacuum waits for its next run around your home.
The dustbin is empty, but the inlet flap has gone out with the dirt. Now your vacuum\'s collection bin has an opening where its dust door used to be.
This SplashNColor replacement dustbin inlet flap puts a closure back at that entry point when the original is missing or damaged. The plastic flap sits at the inlet and works as a hinged baffle: suction lifts it open fully while your vacuum cleans, letting swept dust and debris enter the bin. When airflow stops, it returns closed to limit debris escaping through the same opening. It moves with the cleaning cycle, without a separate opening or closing step from you.
Fitting takes place at your vacuum\'s existing mounting points. The locating pins snap into the inner-shell slots by hand, so installation is tool-free and does not call for complicated changes to the bin. You are replacing the inlet closure where it belongs, rather than changing the container around it.
For vacuum owners dealing with a lost dust door or a damaged flap, this is a replacement for that missing function. Use it at home where you empty and clean the collection bin, then return your vacuum to its usual work around your rooms. It is the part you reach for when a bin-cleaning job leaves you looking for the flap among the debris you just threw away.
The benefit continues when the cleaning run ends. As you lift the dustbin and carry it to the trash, the closed baffle limits debris escaping through the inlet during the trip. When your vacuum is parked on its charging dock, the flap stays closed while suction is off, keeping a barrier across the entry between cleaning sessions. Dust goes in while your vacuum works; the inlet closes when the airflow stops.
Hardware details: the box holds the plastic part only. If your setup needs screws, adhesive or other fasteners, they are not included.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.