DSE703 Auto Start Electronics Controller Control Module Panel for Deep Sea ATS

Applications:
Compatible with Deep Sea ATS

Introduction:
The DSE703 is an Auto Transfer Switch Control Module that has been designed to monitor the mains (utility) supply.When the mains (utility) power fails the module sends a start request to the generator control unit. When the generator is up and running the module transfers the load across. When the mains (utility) returns the module transfers the load back and removes the start command.
The generator should then begin it’s shutdown procedure.The module can be configured so that they follow the users pre-set start and stop sequences.
The module has been designed to monitor over speed, under speed, high engine temperature, low oil pressure, battery charge fail and
fail to start.
The module also has two configurable auxiliary inputs and a configurable engine pre-heat timer. When the module detects a fault condition it automatically shuts down the engine, indicating the exact fault via LED.

Features:
• Manual start
• Automatic start
• Engine pre-heat
• Engine monitoring and protection features
• Protected Solid State (PSS) outputs
• Front panel mounting
• Front panel programming
• Tamper proof engine hours counter
• Remote start
• LED indicators
• Configurable inputs
• Configurable timers
• Configurable outputs
• Engine exercise mode
• Single/three phase mains sensing

On Apr 24, 2025 at 03:12:54 PDT, seller added the following information: