DC Battery Monitor Meter LCD Display 0-200V 0-300A Shunt Digital Multimeter

DC Battery Monitor Meter LCD Display 0-200V 0-300A Shunt Digital MultimeterProduct Features:9-IN-1 Multifunction Meter - Display 9 types of measurement parameters at the same time, including Battery Voltage(0-200V), Discharge Current(0-300A), Discharge Power(0-20000W), Discharge Impedance( 0-1000Ω), Internal Resistance(0-999mΩ), Capacity(0-1000Ah), SOC, Energy(0-9999kWh), Running Time(0-999h).360° Clear Visual Readings - LCD digital screen with blue led backlight, you can easily see all readings at any angles, freely check up your datas whenever at day or night!High Precision Monitor - Built in High precision chips, with only 1% deviation of the measurement accuracy, the meter shows you a stable real-time datas for your wiring devices.Easy Setup - Screws-Free design, with snap-fit tabs on the frame for mounting in a panel or case, while the clear hookup diagrams printed on the back, helps a lot for quick installation.Wide Application - Rated at 0-200v, with 100Amp current shunt, wide suitable for all vehiles, car, pickup, truck, SUV/UTV/ATV, boat, RV, solar panels, etc.Specification:Power: Measuring range: 0-20000WVoltage: Measuring range: 0-200VCurrent: Measuring range: 0-300AImpedance: Measuring range: 0-1000ΩInternal resistance: Measuring range: 0-999mΩCapacity: Measuring range: 0-1000AHMeasurement accuracy: 1%SOC: Dump energy is display via the battery symbol, totally 10 grids, every grid present 10% energy.Energy consumption: Measuring range: 0-9999kWh (Note: 1Wh=0.001kWh=0.001 Kilowatt)Running time: Measuring range: 0-999 hours (without load the time will not accumulate)Warm Tips:- If you run all negative current for all batteries through one shunt of the meter, then it would read for those batteries, pls making sure use within 300A.- If you want to know how long your batteries will last under the current load, please calcultate by the formula, Amp Hours of the Battery ÷ Current Draw=Time.NOTES:1. If test voltage is lower than 8V, please use the independent power supply mode, refers to the instructions.2. Wiring order cannot be wrong. (For indoor use ONLY.)3. The loads should not be exceed the rated power or current.4. Use a needle tool to press the function button to prevent accidental touch.5. The current is set according to the specification of the shunt.