Free Userbar - Userbars - User Bar - User Bars
 
Advanced search
Registered users

Username:

Password:

Log me on automatically next visit?

¬ Forgot password
¬ Registration

» Upload Userbar
» Animate Userbar
» Userbars Tutorial
» Userbar Tournaments
» Forum
» Chat Room
» FAQ
» Links

• PC Cheat Codes

>> If you dont know how to design a userbar, then write here a Userbar that you want. >> If you know how to design them help these people and design what they request.




USERBARS.org | Free Forum Userbars

On eBay now
eBay

DC 6V 12V 24V Forward Reverse Motor Controller Relay Limit Switch Driver Module

DC 6V 12V 24V Forward Reverse Motor Controller Relay Limit Switch Driver Module
$9.68

Buy Now

Parameter

  • - Working voltage: 6.0~40V DC (recommended 6-36V )

  • - Rated current: 5A

  • - ModulePower consumption: 0.6W (without load motor), static 0.1W

  • - Signal input: availbe in low-level , inputOptocoupler is negative pole. if voltage below 2V that means have signal

  • - Response speed: K1 K2 are 20mS , SW1 SW2 are 50mS

  • - Size: 83 * 46 * 20mm / 3.27 * 1.81 * 0.79 inches

  • - Active life: > 1.5 million times


Function Description:

Forward and Reverse start buttons: K1 / K2 ; Limit Buttons: SW1 / SW2

Self-locking mode:

1- short press K1, the motor starts running forward immediately and stops after SW1 is closed.

2- short press K2, the motor starts running reverse immediately and stops after SW2 is closed.

Inching mode:

1- press and hold K1, the motor starts running forward immediately and stops after SW1 is closed.

2- press and hold K2, the motor starts running forward immediately and stops after SW2 is closed.


Package:1pcsTKS-M8 DC Motor Driver ModuleFrequency Q/A

1. what\'s the difference between \"inching\" mode and \"self-locking\" mode

self-locking mode: short press the forward switch (k1) , the motor running forward , even you release k1, the motor still running. it will not stop until encounters a reverse signal (k2) or (sw2) .

incing mode: press and hold the forward switch (k1) , the motor running forward, if release the k1, the motor will stop immediately.

2. what are the requirements for the signal ? Can i connect a sensor ?

signal is vaild at low level , it can be connected to three-wire sensors (NPN-NO type), k1 , k2 , k3 are this type.

3. Is the limit signal valid in inching mode ?

valid. such as when k1 is on , motor will run forward , but the SW1 also have signal , it will stop at this time.

Buy Now

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Related Userbars
       

More items on eBay

As an eBay Partner, userbars.org may earn a commission from qualifying purchases.



All userbars are property of respective authors.
Copyright © 2002 4homepages.de | Template © 2005 Bali Web Design