Continuous Mixer Parts
Making your own continuous mixer is easyenough if you don\'t want a pre-made TFM Engineering one, but the finicky bits are thesensor holder, gas injection point and a mixing chamber that you can relyon. These parts will help if you\'remaking your own or altering an existing system.
Warning:improper placement of oxygen sensors may result in an acceptably high level ofoxygen going into your compressor and causing vast amounts of damage, injuryand death to you, your compressor and everything/everyone around it. Don\'t use them unless you are prepared to properlydesign, build and test your system, and take responsibility for any and allcatastrophes that result!
Part #
Description
11-003
Mixing chamber, 25BSPT threaded - will work for compressors up to 10cfm. It\'s neat and compact, and very effective at mixing the gas stream.
11-004
Oxygen sensor holder, 25BSPT threaded (sensor NOT included) - drilled and tapped to suit sensor thread. Recommended install at a right angle bend in the flow path to promote turbulence and washing of gas over the sensor.
40-201
PSR-11-39-MNB AII Analyser Only Oxygen Sensor (molex). Budget sensor that will get the job done. (all oxygen cells are consumable and will last 1-2 years if looked after)
11-005
Gas injection port, 25BSPT threaded - oxygen clean brass 6mm push-in fitting with diffuser. Recommended install on one end of tee so gas flows straight into the mixer.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.