|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Code Alarm DIYTX Replace Keyless Entry Car Remote Alarm Fob Transmitter ELVATDB
$39.95

This item is pre-owned – it will work like new once programmed to your vehicleOne (1) Aftermarket remote keyless entry fob alarm Transmitter control clicker keyfob controller replacement Functions at 100% Tested & GuaranteedCode Alarm FCC ID: ELVATDB Part #: DIYTX Interchangeable Part Frequency: 433 - 434 MHz LED color: Red 4 buttons Battery: (2) CR 2025 Compatible w/ the following CSI400 Programming Instructions: Note: You will need to use the valet switch (programming/override button) to perform the programming procedure. It is possible to perform programming without the valet switch but you would need to access the receiver under the dash. 1) Enter the vehicle, and turn the ignition switch to the ON position. 2) Press and release the Programming button switch 3 times. 3) Press and hold the LOCK button of the transmitter you wish to program. 4) The lights will flash 1 time, indicating that the system is accepting the programming of channel #1 which is lock. \"Repeat step 3 for each transmitter you wish to program\" 5) Press and release the valet push button switch 1 time to advance to channel 2. 6) Press and hold the UNLOCK button of the transmitter you wish to program. 7) The lights will flash 1 time, indicating that the system is accepting the programming of channel #2 which is unlock. \"Repeat step 6 for each transmitter you wish to program\" 8) Press and release the valet push button switch 1 time to advance to channel 3. 9) Press and hold the TRUNK button of the transmitter you wish to program. 10) The lights will flash 1 time, indicating that the system is accepting the programming of channel #3 which is trunk. \"Repeat step 9 for each transmitter you wish to program\" 11) Press and release the valet push button switch 1 time to advance to channel 4. 12) Press and hold the STAR button of the transmitter you wish to program. 13) The lights will flash 1 time, indicating that the system is accepting the programming of channel #4 which is remote start. \"Repeat step 12 for each transmitter you wish to program\"

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|