Free Userbar - Userbars - User Bar - User Bars
 
Advanced search
Registered users

Username:

Password:

Log me on automatically next visit?

¬ Forgot password
¬ Registration

» Upload Userbar
» Animate Userbar
» Userbars Tutorial
» Userbar Tournaments
» Forum
» Chat Room
» FAQ
» Links

• PC Cheat Codes

>> If you dont know how to design a userbar, then write here a Userbar that you want. >> If you know how to design them help these people and design what they request.




USERBARS.org | Free Forum Userbars

On eBay now
eBay

Cincinnati Reds Full Size Batting Helmet Raised 3-D Logo. 2". See Details

Cincinnati Reds Full Size Batting Helmet Raised 3-D Logo. 2". See Details
$14.95

Buy Now

Don't see the team or the color or the size logo you were looking for? Message me. Chances are I can make what you need!


Please note. These logos are paintable if the color does not match your expectations. Just lightly sand the logo, clean, then paint!


This logo has a 3-D look to it. Around 2 mm thick. 2 inches tall.


Perfect size to glue on the front of a batting helmet.


See pictures for best details.


We ship fast.


These logos will come flat but you will need to heat them up with a hair dryer and make them pliable then form it to the curvature of your helmet. This will make them easier to glue on.


Helmet not included!


Glue not included!



Instructions for applying logo:



Heat up the back of the logo with a hairdryer until it’s a little bit flexible. Don’t heat it too much or you could warp it. (Start with 10 seconds)



Once it is warm and pliable press it and hold it on the curvature of your helmet until it cools down and it will stay like that. (Heat for another 10 seconds if the first try wasn’t enough) All corners plus the top and bottom should sit flush against the helmet.



Next put tiny drops of glue on the back of the logo and spread it thin with a toothpick like a peanut butter sandwich. (I use E-6000 glue)



Place the logo where you want it and press down gently. Try not to slide it around or you will have an ugly mess behind the logo.



Lay the helmet on its back in a box or something to keep it from moving around. Make sure the logo is looking up towards the ceiling so gravity doesn’t pull on it.



After about an hour go back and wrap rubber bands around the top part and the middle part and the bottom part of the logo. Wrap it around the back of the Helmet and hold the logo down with your finger while you’re doing this in case it wants to slide but it should be set up enough at this point where it won’t.



Make sure the rubber bands aren’t trying to pull the logo up or down or sideways. All three rubber bands should be pulling straight back so adjust the rubber bands on the back of the helmet accordingly.




Leave it like this for about 24 hours. After 24 hours you can remove the rubber bands and gently touch the logo to make sure it has a hard bond.



Buy Now

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Related Userbars
       

More items on eBay

As an eBay Partner, userbars.org may earn a commission from qualifying purchases.



All userbars are property of respective authors.
Copyright © 2002 4homepages.de | Template © 2005 Bali Web Design